But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi, this is kind of a basic question.
So please forgive me if this is too easy...
This picture is from nRF51822_PS_3.1.pdf.
Also these pictures is from the...
I am trying to use a differential antenna with the NRF51422 and I do not want to misunderstand the datasheet. It says that the optimum differential impedance at 2.4 GHz seen...
If, how can I change the order of the descriptor? I would like to have the user_desc at first.
Most likely by changing their UUID but how to do that? I can't find any trace...
Hi every body,
i try to use 10 bit ADC resolution instead of 8 bit in the ble_uard_adc example, the problem is the ble_nus_send_string is configure to 8 bit, how can i...
Before I order the NRF51-DK I want to make sure, is it possible use it to program other nrf51822 modules? Can I use the Segger on board for flashing firmwares on other modules...
Hello,
Let me first try to describe my whole project I just started with today (Hardware just arrived).
I want to use the nRF51-DK as a central device to handle 4 peripherals...
I have these nrf51822 modules, bought them from this company Wireless Tag , it's a chinese company I guess but I just noticed that the modules only have a single 16 MHZ oscillator...
I using github code.
SDK is 7.0.1
SD : S110 7.1.0
Channel : 4 ch
Period : 20ms
Width : 1-2ms ( RC )
Sometimes the width operates at 18-19ms.
ex : PWM2 was...
I'm working with the ble_app_hrs_s110_with_dfu_pca10028 (nRF51 PCA10028) example and am wondering what will happen if I attempt to send more than one sample at a time. Will...
It looks like APP_TIMER_INIT changed in v8 of the SDK. I do NOT want to run the code for timer callbacks in the IRQ, I want to run in the background loop. How should I properly...
Hello,
Our application board uses two NRF24L01P and two microcontrollers, so we have total four quartz generators on board. To simplify things we would like to use a single...
I have a project which measures temperature and humidity. After measurement the data should be send trough BLE.
I have one service for the sensor and two characteristics...
Hello,
what do I need to pay attention to calculate the consumption of nrf51822 in low power mode (sleep).
I make this simple program :
=========================...
