Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hello,
I'm currently trying to pair my board with my phone and I've faced some issues.
After downloading my device(NRF52 PAC10040 board) with experimental_ble_app_blinky...
Hi all Nordic developers,
I am currently working on nrf51 to scan all the nearby beacon and then i wish to send the data to the esp8266. I already able to scan all the...
When I try to copy a zip file from my email to NRFToolbox for DFU, the NRFToolbox app comes up and then immediately crashes.
Steps to reproduce:
Download latest NRFToolbox...
Hello, as it is clearly understood (by everyone developing using NordSemi's SOCs), this struct "ble_evt_t"
Hello, as it is clearly understood (by everyone developing using...
Hi,
I've read in your press release for SDK 12 that increasing the MTU beyond 23 bytes is now possible on the nRF52. I thought I'd test this increase out on my nRF52 with...
Hi All,
I have a basic question, i want to know what are the right value to use with the nrf51422 chip for the resistors with ADC.
I want to use the maximum value permitted...
Hi, I have problem with using example codes. I want to add GPIO control to ble_app_uart example. Adding gpio_config() function taken from app_timer_tutorial blocks program...
I'm using NRF52832 SoC and IAR
I've to read data from ADC using SPI. ADC will generate interrupt every 4ms indicating data ready. I've configured GPIOTE to sense the ADC...
A couple of power consumptions Q's for this basic scenario: RTC used via PPI to infrequently sample from ADC and trigger SPI read from external sensor source.
Questions...
Hello,
I need a support for BMD-300 BLE module.
We can flash the BLE module and we can connect it with mobile application via Blue-Tooth.
But when we flash BLE for...
Hi,
I'm using nRF51822 in my senior project (some kind of BLE wearable device).
I'm trying to call my function inside the ble_evt_dispatch() function but it doesn't...
SPI Slave configuration On nRF52
Hi,
I am trying to configure the SPI slave peripheral for interrupt based communicaton with a SPI master
In previous work with ARM...
