Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
i am using nrf52832 pca10040. i tried to run the ble blinky example from package installer. it compiles without any error, but when is load it to the DK it will not even advertise...
NRF52832 is bluetooth pre approved SoC. So still need to pay Buetooth SIG to sell my Bluetooth based product in INDIA ???
Can i Sell non Certified product Without FCC CE...
Hi Nordic Forum!
Looking for the right configuration for the connection parameters, found different references to this Apple guide .
The problem is that in the 3rd condition...
I'm working on a project where I need to recognize whether or not a wireless tag is within 5-10' of a stationary reader. I would develop the reader system using a module,...
Hello,
I am using IAR Embedded Workbench for ARM ver 7.6. We are using nrf52 with SDK 11 and the corresponding soft device.
We are having a problem with the uart sending...
we have
/**@brief Function for initializing BSP.
*
* @details The function initializes the board support package to allow state indication and
* button reaction....
Hi,
I'm trying to connect to a Raspberry Pi from an nRF52832 via BLE Central mode. The Pi is running a node.js app (via bleno) and I can connect and communicate with it...
i m using pca10028.. with gcc tool chain setup with sdk 8 in windows.....am run one ble_uart example and after 180 second my device goes to sleep.. and second one that i have...
I'm using the SAADC of an nRF52832. I'd like to reduce the error of my measurements from the nominal +/-3%. I'm calling the NRF_SAADC_TASK_CALIBRATEOFFSET periodically to...
Hi,
I am trying to use nrfutil to generate my verification key.
However in the bootloader the key has this format
__ALIGN(4) const uint8_t pk[64] =
{
0x6e, 0x76...
Hello,
I am trying to update my bootloader using DFU and I am running into a few issues. I have successfully flashed and tested my current bootloader on my board and everything...
