Hello team,
We have a problem here, we are running a new program with 5 years long-term standby IOT device, once we are trying to use SMS to configure the IOT device we...
In our development using NCS-2.6.1 it is desirable to have logs using BT NUS.
"Serial Bluetooth Terminal" android application is used.
For testing purposes NCS\v3.0.2...
Hello,
I'm trying to hold the TX line of UART0 low for 1 second. I'm using NCS 2.9.0 on an nRF5340.
Disabling UART and setting the pin directly works.
But after reenabling...
Hi,
I want to port an exisiting solution from ESP32 + nrf24 to nrf54L15. I didn't find any example that would work out of the box for my POC which would to combine very...
Hello,
I am working on a hardware design with two MEMS PDM microphones and a mono speaker. I think I have the peripherals allocated and wired correctly but wanted to run...
Hi,
I just started with the nrf 51822 eval kit. I've used keil before and am using the evaluation version. The Blinky example compiles, uploads and can debug fine (step...
Hi everyone:
by default , when a port(Port0) setting to output mode.
when i want to read the port(Port0) ,
i will get the port Output state. but at the nRF51822(NRf6310...
I have the nrf51822 eval board and I am just trying to download the blinky project. I have followed the quick start instructions in the nrf51822 user guide but every time...
Hi
In Desktop 2 v1.0.4, did you consider the debounce as keyboard buttons were pressed or released?
How long is the debounce confirming time? Thanks.
Jeffery
Hi, my name is nils. I am trying to develop on the nrf51822 eval board. I use eclipse an gcc with the j-link under windows 7 to programm/compile/and flash. I got it to work...
Hello,
We are working in the field of Electric Bike Propulsion Systems.
We want our motor to be able to communicate to I-phone/Android phone on Bluetooth.
We are searching...
Hello Nordic experts,
I can find current consumption in standby mode data from nRF24L01plus datasheet.
But it seems standby mode current consumption is not mentioned in...
We would like to be able to communicate with an nRF51422 target system from a Windows host. (for target signal processing algorithm debugging ).
Our previous system used...
how can I program SPI to select more than only one slave device with any GPIO ?
SPI Routine "spi_master_int" can select SPI0 or SPI1 only with one dedicated GPIO as Slave...
I want to know the EXT interrupt (GPINT1 & GPINT0) can use at the same time. When I use the GPINT1 & GPINT0 at the same time,only one is OK the other is faile.
I'm looking at the led.c example in the heart rate monitor example. What this shows is how to tie a TIMER event to toggling an LED. I understand most of the mechanism there...
