Hi,
I am trying to perform a DFU using SMP over BLE. My setup has NSIB and MCUBoot enabled and thus I am able to perform DFU for MCUboot and Application using nrf device...
Hi all,
I'm trying to use uart2 on my custom nrf9151 board, but I'm stuck. As I understand, I use i2c1 so I can't use uart1 and i2c1in parallel, so here is why I wnt to...
Hi - I am seeking clarification on a topic as I am a little unsure on the correct way to do things.
I'm using an nRF52840 and porting an old Firmware from nRF5 SDK to NCS...
Hello,
I'm moving my project from SDK1.9.1 to SDK3.0.2. Project is based on peripheral_uart sample (UART part is removed since it is not necessary).
I have encountered...
Hi, i'm using NRF5191 with DECT.
DECT modem: 1.0.2
App: hello_dect sample
In datasheet I found that NRF9151 support various band: 1,2,4,9,22
and I'm using these value...
Hi there,
on the nRF5340 Audio DK, there is a FT2232H, which provides FTDI_SPI + FTDI_SPI_SEL.
How this can be used, is there any sample for this available?
And how...
Hi
I have some questions about nRF5340 & nPM1300 decoupling cap
nRF5340
1.For pin A3/D2/H11/K1/L5/L11, ref. SCH is 1uF*1 and 0.1uF*5, could we only connect 1uF*1 and...
I am trying to work on ble_app_uart example project working.
I am able to see that the "nus_data_handler" is triggered when any data is received over the BLE channel. On...
[Duplicate question. See the original post here ]
Dear Nordic team,
I have purchased Bluetooth Low Energy, Beacon module with ARM Core from Tindie
They gave me...
Hi,
Im trying to send data via the NUS service which is larger than 20 bytes. I understand that I have to break down the data into chunks in this case, which is what I...
I am new to embedded programming.
I use JLINKEXE (on Mac) to load the S110 softdevice and my application. When I am in the debugger, the app loads and all runs as expected...
Hi there! Running a bootloder of sdk 9.0 on nrf51822, a problem occurred in a special way. In a normal way, program softdevice and bootloader with studio respectively, then...
I will write time to my ble device and need write uint32_t via characteristic. When i try only (uint8_t)data[0] is correct.
How can I do writable characteristics (uint32_t...
Hi,
I have a peripheral device with custom Services and characteristics which is working properly (I can tell because it got tested with nrf Master Control Panel app)....
My PC completely bricked so I'm setting up Eclipse and GCC on a new Machine. Everything seems to work except I'm getting two odd compile errors on INLINE functions. The compile...
Hi,
i am using blend micro with nRF8001 .. i want to make the bluetooth module to sleep on an interrupt such that it should consume the lowest power.
thanks in advance.
I want to use Seggers RTT for data logging.. but after 199lines the Viewer starts to overwrite the old lines.. so that only the most recent 199 lines are displayed..
Are...
Hello,
I want to use nRF8001,but I'm a beginner for nRF8001,I have no idea how to start my software design.
Could anybody give me some guide about how to start my design...
Hello Everyone
i have been trying to implement the pwm library from the GITHUB inorder to make the buzzer beep sound but after compilation it is showing these two errors...