Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
Hi,
Can any one suggest me how to program SoftDevice and Application program to nRF51288 BLE Motherboard using Keil 5? Please specify how much IROM1 and IRAM1 allocation...
I've studied the nRF OpenMesh for a couple of days, and could run the BLE_Gateway example among serval nRF51DK boards.
But now, I still don't have any feeling/concept about...
Hi, I’m looking for a data streaming solution to wirelessly transmit data over a short distance. Important points are:
unidirectional point-to-point transmission
...
Good morning,
my problem is that this module has a very short range.
The maximum range that I found was 4 meters.
Have you any solution for increasing this range?
Thanks...
Hi,
I saw several structs that you have in your library and I am curious as how you are forcing the alignment, since I want to do the same.
This is one of them:
typedef...
We are currently working on NRF52 DK.
I know that a Segger RTT is used to print the debug message using a Real Time Terminal(like TeraData or Hercules).
I know that...
Hi :)
I developed my Bluetooth app with MBed and the RedBear BLE nano module. My jumper wire installation connecting an stm32 with the module is working great and everybody...
Hello,
what is the initial output state of the comparator in single ended mode, if the input voltage is between the upper and lower threshold?
Is it undefined, always...
Hi,
I have a question regarding the nrf52 UARTE driver. I have the basics setup and working, I can send and receive data using the UARTE.
What I need to do now, is find...
Hi all,
Someone, please, can give me an information about programming a board nrf52832 using the pin SWDIO/SWCLK.
There is an application note that explain this topic...
I don't know where to submit these things.
I don't fully have my DFU working yet, but clearly I have a badly formatted init packet. However, the resulting behavior was...
If an app is advertising on all channels, and receives a SCAN_REQ on 37, will it transmit the ADV_IND (and potentially SCAN_RSP) on 38 and 39, or is advertising interrupted...
