I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello,
I have been looking to program this IC, connecting via SWD with no luck. I can connect to the target but for some reason once i try to perform erase programming...
Hi
Is there any limitation to characteristic size for use in notifications?
The reason for asking is the following:
I have a service with a characteristic with size 24...
I am trying to bond a central nordic board to another nordic board acting as a peripheral, however somewhere along the way the bonding fails. I started on the peripheral side...
Hi,
Since there seem to have issues with Android and stuff about long writes, I was wondering if there was a possibility to customize the allowed length in the device name...
I have designed new device based on nrf51822 chip. New PCB with your chip and other elements. I with my team want to sell the standalone device with update possibility by...
Hi all,
i'm doing some beaconing experiments with my NRF51-DK, a RFX2411N-EVB and a HG2408U antenna. I'm using S110 with beaconing demo code, and nRF Connect app to measure...
Hello.
I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB.
I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...
So having first used Kiel, then Eclipse, it was great to finally ditch my clunky windows laptop with its terribly laid out keyboard by making the transition to Segger Embedded...
hi,
i am integrating c++ library with the ble_app_uart example code. using s130 on pca100028 board. in the make file i have made changes by replacing
CFLAGS += -mthumb ...
I want use pwm driver to generate 8 channel pwm wave with nrf52832， My board is PCA10036. I use example “nRF5_SDK_11.0.0_89a8197\examples\peripheral\pwm_driver\pca10040\arm5_no_packs...
Hi,
Can anyone tell me about fstorage module and can I use this storage space to store password? Will it give me any extra level of security? If so how to implement and...
I use a nRF51 dongle for some tests and I want to map the UART interface of UART_example on the pins 15,16,17 and 18 of the Dongle.
I try to juste adapt this lines of code...
I want to know the architecture of transmitter of nRF51822. I have questions as follows.
Does the block diagram of nRF24L01 show it? (nRF51822 has on-air compatibility...
