Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Dear Nordic family,
I am using Bluetooth Low Energy, Beacon module with ARM Core from Tindie ( Product link ). The reference manual from their website is attached IMM-NRF51822_RefMan...
I am trying to work on ble_app_uart example project working.
I am able to see that the "nus_data_handler" is triggered when any data is received over the BLE channel. On...
[Duplicate question. See the original post here ]
Dear Nordic team,
I have purchased Bluetooth Low Energy, Beacon module with ARM Core from Tindie
They gave me...
Hi,
Im trying to send data via the NUS service which is larger than 20 bytes. I understand that I have to break down the data into chunks in this case, which is what I...
I am new to embedded programming.
I use JLINKEXE (on Mac) to load the S110 softdevice and my application. When I am in the debugger, the app loads and all runs as expected...
Hi there! Running a bootloder of sdk 9.0 on nrf51822, a problem occurred in a special way. In a normal way, program softdevice and bootloader with studio respectively, then...
I will write time to my ble device and need write uint32_t via characteristic. When i try only (uint8_t)data[0] is correct.
How can I do writable characteristics (uint32_t...
Hi,
I have a peripheral device with custom Services and characteristics which is working properly (I can tell because it got tested with nrf Master Control Panel app)....
My PC completely bricked so I'm setting up Eclipse and GCC on a new Machine. Everything seems to work except I'm getting two odd compile errors on INLINE functions. The compile...
Hi,
i am using blend micro with nRF8001 .. i want to make the bluetooth module to sleep on an interrupt such that it should consume the lowest power.
thanks in advance.
I want to use Seggers RTT for data logging.. but after 199lines the Viewer starts to overwrite the old lines.. so that only the most recent 199 lines are displayed..
Are...
Hello,
I want to use nRF8001,but I'm a beginner for nRF8001,I have no idea how to start my software design.
Could anybody give me some guide about how to start my design...
