Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
i am working with the Enhanced ShockBurst proprietary protocol and i am wondering where I can find the sources of this protocol, so that I can do some changes. ...
[uart - Copy.rar](/a master _error.png ttachment/3cc01f5e2484d2b0f33e62befd3e6a62)
hello there
I am interfacing master nrf51 dk with nxp's slave lpc11u24
(1) my main...
Hi there. I'm making a sensor system which is intended to measure an ADC value, and send it using the Heart Rate Sensor template. To make this, I've rebuilt the ble_app_hrs...
Hi
Does the newly released nRF52840 chip have pins on the side, corresponding to the "outer ring" (A8-23, AD2-23, B1-W1, ...) pins on the underside of the chip, like this...
hello i am interfacing i2c sensor mma8452 with nrf51 dk. my function is
void mma_read(uint8_t *x, uint8_t *y, uint8_t *z)
{
uint32_t err_code;
uint8_t rx_buffer...
I have to sample 3 differential channels periodically. Should I calibrate SAADC for each channel individually? Unfortunately, "nRF52832 - Product Specification v1.0" doesn...
Update 2016-Mar-29: I used SDK v10 along with SoftDevice S110 v8 when I run the experiments described in this question.
Update 2016-Mar-30: Upload source code of the modified...
In order to perform dfu to softdevice S132 v3 sdk12 (secure bootloader) from sdk11 softdevice S132 v2 (legacy bootloader).I've change the legacy bootloader as it it says here...
by using Arduino mini pro 3.3v
I am planing to measure the temperature for the first five minutes, if the temp is over 40 degrees the device will send to Android app and...
Even though the SIG hasn't finalized yet and the 1.4.0 SoftDevice isn't out... Can we get a heads up on what to expect for 1.3.0 BLE 4.2 compatibility?
On something...
In arm_startup_nrf52.s (in the 8.9.0 device family pack), there is a new bit of code:
IF :DEF: __STARTUP_CONFIG
#include "startup_config.h"
ENDIF
I assume this...
Hi,
I'm thinking of using the NRF52 for an embedded wearable sensor application.
How much flash and Ram space can I expect to have remaining approx. for my application...
I'm a bit at a loss of how to voluntarily stop advertising: My related thread says I should call sd_ble_gap_adv_stop() , but when I do, no corresponding event is raised by...
