Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
nRF52 DK, PCA10040 v1.2.1
PPK PCA63511 rev 1.1.0 2018
I am connecting the PPK to the NRF52 DK in the simple case where I want to measure power consumption of the 52832...
I'm trying to get nRF sniffer to work in wireshark. I followed all the steps from the nRF sniffer user guide, but I can't get it to work.
The issue: - when I have the PCA10040...
Hi,
I tried to build your own example about "fatfs" on my board "nrf52840pdk" ( with MyNewt as OS ) but it seems that "ff.h" can't be found. Has it got any dependencies...
An nRF5 SDK for Mesh v2.2.0 dimming example client running on a nRF52840 Preview DK is not detected for provisioning by a nRF Mesh smartphone provisioner.
Running the example...
I am in process of doing my eng. thesis and apart from setting up Thread network part of my work is to measure delivery time of messages.
For now I have an application based...
Hello!
I am using NRF51822 in receiver mode with enabled interrupt on ADDRESS event, and even if transmitter is switched off I still get a few messages every second. It...
hi........
i have customized one program ....using segger 15.2 ...nrf52832
when degug it,the code from button and leds stops at nrf_breakpoint_cond ... even it doesn't...
When performing pre-qualifying Bluetooth radiotest of our hardware (utilizing the nRF52840-chip) at NEMCO, we experienced very strange behavior. The frequencies detected in...
My setup of the buttonless BLE DFU secure bootloader using SDK15.2 isn't launching the application after a successful OTA package transfer. Using RTT and breakpoints, I narrowed...
Hi ..
I am using nrf52832 and peripheral device sensor ..segger 15.0
Is it possible to wake up from sleep by interrupting the sensor .. possibility is there ??
Hi,
I am shifting my program from version 11 to 15.2. While including SPI files to the ble_app_uart code, I met with this issue. I have enabled all defines for SPI interfacing...
I'm trying to get the ble_app_uart example working on a nRF52810. I'm using SDK 15.2.0 together with Softdevice S112.
The infocenter says the Example needs Softdevice S132...
I'm facing the issue, that the app_ble_uart example just works if I hook up TX/RX of my USB - UART converter. Is this a desired behaviour? It doesn't seem to start and advertise...