Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello,
I am running an application on the s140 soft device using the buttonless dfu as an example. I am using the dual ramp pwm scheme to generate complementary pwm waveforms...
I'm having some issues with the 9160 on battery and wondering if we're doing something wrong or if this is expected behavior. During the initial connection to the tower, I...
We tried to adapt the RTC example from the SDK to add logging via UART during interrupts and the programmed crashed or hanged.
Here follows the code we are using :
The...
Hello, I have an application based on the example "ble_thread_dyn_mtd_coap_cli_pca10056_s140".
When a confirmable message has not received a response, I receive the error...
Hi,
We have built an iOS app with the iOS nRF Mesh Library ( https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library ) that collects data from all the sensors in the...
I am using nrf Toolbox iOS demo application. I have a requirement in which I want to change the incoming data stream to accept 4 bytes of data instead of the default 2 bytes...
Hello,
I am migrating our production code from SDK14.2 to SDK16, and switching to using FreeRTOS. During the BLE initialization and bonding, I get a system reboot. Tracking...
Hello,
Using an Arduino nano 33 ble which contains a nrf52840.
Using arm-none-eabi-gcc version 9.2.1 in debian/linux, uploading using openocd en gdb.
I tested my problem...
As I'm new to the nRF52840 and Bluetooth, I read documents and DevZone posts related to the bluetooth maximum throughput.
According to the references like Jimmy and Sigurd...
Hi,
I am trying to update from SDK 1.3 to 1.4 and struggling with crashes. COAP uses random number generator to generate new tokens to the header. First time when this...
Hello,
I use the default ble_template application from the SDK and download a BLE custom service template from here to add it to the template code (as described in the README...
Hello,
I have a fully functioning project using the Fanstel BT840 chip which uses the NRF52840. I am running the code using secure Buttonless DFU and the S140 soft device...
So, I am developing an application where I will use uart to transmit some data from the PC to the nrf board. The issue is that the data I am transferring is quite large (64KB...
