Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi Every one,
In my application i want to use two UART's simultaneously, for that i am doing continuous switching of UART communication pins.
I am able to communicate...
Hello,
I am trying to designe my own iot sensor board with nrf52840
For my sensor board i will just add lipo charger IC and MPU6050 (accelerometer)
When i look at designe...
Is there a generic sdk_config.h file for each of the Nordic SDKs?
The ones included for each example seem to be missing useful macros/defines, for example, omission of SEGGER_RTT_CONFIG_DEFAULT_MODE...
Having trouble using a Raspberry Pi 3 as BLE/6LowPAN router in the IoT MQTT example project from nrf5_sdk_15.2.0
I was recommended to use Ubuntu box instead of Raspian(it...
I maked this question because I don't see any example about MQTT-SN client with FreeRTOS. MQTT-SN client libraries in SDK using many timer from app_timer. I don't know whether...
NRF Connect displays only a white screen after some time.
I can connect to my nrf51DK with the ble or the PPK app, but after some seconds (changes between 1-20) only a white...
Hey, I am trying to get a bluetooth mesh up and running with the nrf52832 dev boards (PCA10040) acting as nodes and a Raspberry Pi 3 (with bluez meshctl) as the provisioner...
The implementation in generic_dtt_server.c doesn't properly validate the set message parameter and generates a response despite the message should be ignored.
The Mesh Model...
NRF52 devices and Softdevice 132:
According to SoftDevice specification v5.1 Table 4: Peripheral protection and usage by SoftDevice NRF_FICR data such as ->INFO.PART, DEVICEID...
