I am getting following error:
Error in final launch sequence
Error executing step execute method: stepInitializeJTAGFinalLaunchSequence
java.lang.reflect.InvocationTargetException...
Dear Nordic people,
I am playing (6.0.0) with sd_flash_page_erase() and sd_flash_write() , seems to be working ok, Allways happens what I do expect, but I am not able to...
Hi,
Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422?
Also would you happen to have a time frame as to when the Rev 3 will...
Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am trying to power off and/or disable a RR[0] with no success.
I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...
Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...
I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...
Hello all,
I want to enable OTA DFU capability to NRF52840 BLE Chip. I am now using Buttonless DFU which works fine using nrfutil. But my question is : how can we update...
Hi
I'm upgrading from SDK11 to SDK12 on the nrf52 and part of that is the secure bootloader. I've created a new bootloader and have this working with the new softdevice...
Hi,
I tried to open the mqtt_simple project on the nonsecure ns nrf9160 DK using SES and after that tried to build and run the project which was successfully done but the...
Hello,
I'm wondering what are the drawbacks of the already burned random static mac address compared to a public mac address. I know the difference between the two address...
I have Wireshark setup with old PCA10028 board connected as a sniffer, FW sniffer_pca10028_51296aa.hex Now I'm working with NRF52 family and sometimes I need to observe some...
Hello everyone ,
i want one central uart and three uart peripheral , i want to connect the central to all three peripheral , if i send data from central , it should receive...
Hi
I have a problem with showing data packets in wireshark. I configured the sniffer according to the instructions. At capturing packets in main window don't show anything...
I want to use UART.
I checked the waveform and UART does not send data. Here is my code. build and run are successful. Any help? I connect UART RX and TX directly, which...
hi... how to make a nordic app to act as a peripheral , i have read one post , in that they mentioned set up to be done in gap peripheral mode . how to do that
IAR 7.60
52840
nRF5_SDK_15.2.0_9412b96
Hi there, I'm trying to do some modification in the bootloader (so that we can write the image to the flash's bank1 using our...
Hello,
I read through the Bluetooth core specification in order to get a better understanding of the information that has to be stored at a minimum if using bonding. But...
Hello,
i'm trying to use ble_advertising_init to initialize my advertising data, but when i use this function like it is used in the examples i get NRF_ERROR_INVALID_PARAM...
When I open device just after I plug it in the PC it work fine, but when I try to do it again (exit python script and run it again) I'm getting Error code 13.
Firmware:...
We are currently in the prototype stage using the nRF9160 and are preparing the firmware for the prototype. We have a few question that we hope someone could answer :)
Will...
