Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
Hi,
Earlier today the forum appeared empty and none of my old posts were visible under profile > questions. Another user also had this issue. The front page looked like...
So I'm trying to follow this tutorial - https://devzone.nordicsemi.com/b/blog/posts/getting-started-with-nordics-secure-dfu-bootloader to generate secure OTA DFU
I've got...
I have set up a simple test to check if scan request can be used as an acknowledgement for advertising packets. I send some distinct advertising packets and multiplex them...
Hi everyone,
sadly my nRF51-DK boards seems to be terribly bricked.
During firmware update nRFgo Studio (on Windows) stopped responding.
I can't enter bootloader mode...
Hello,
I am currently trying to add SDK15 functionality to a mesh project as shown in the documentation.
http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
Hello,
I am working on a project with nRF51822, I want to connect two or more nRF51DK boards using SPI and send an interrupt from one board to another, Is there any code...
Hi Nordic,
I am using SDK 12.3.0 and S130 2.0.1. I would like to ask some questions about Peer Manager.
1. I want to erase all bond when I press a button. Do I just...
Hi,
I have been trying to read the register values, from BNO_080, using the functions nrf_drv_twi_tx to write and nrf_drv_twi_rx to read. But for some reason, i have been...
Hi!
I gave up trying to come up with a working solution for updating mesh nodes based on SDK1.0 to SDK2, see https://devzone.nordicsemi.com/f/nordic-q-a/37707/dfu-update...
Hi,
I read this post to handle communication with both built in UARTs
I'm working with Mesh SDK 2.0.1 and nRF SDK 15.0.0 at the moment.
My application uses UART0 initialized...
I noticed that the secure bootloader by default protects bond information during FOTA. In earlier SDK versions there was something called preserved pages right below the bootloader...
Hi, Im using this library, https://github.com/NordicSemiconductor/Android-BLE-Library/, Everything works great except the disconnect part, I need to press the disconnect button...
I had setup nRF sniffer with below software and hardware, but the Wireshark seen unable capture BLE data.
nRF Sniffer software nrf_sniffer_2.0.0-beta-1_51296aa.zip ...
