Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I'm using nrfx_saadc V2 in nRF5 SDK 17.0.2. In nrfx_saadc_abort nrf_saadc_task_trigger(NRF_SAADC_TASK_STOP); is called regardless of if the ADC is currently running. If the...
Hi!
We're using the nRF52810 chip, so we have a very limited amount of flash memory. We're looking at every opportunity to save some space. We currently run with a modified...
I've got the USB CDC ACM example up and running. I'd like to do something similar on the nrf52840 Dongle but rather than using a UART for the CLI, I'd like to use a second...
hi support team,
customer has one question about USB device to restart manually, because customer need to change the HID descriptor for some reason.
i tried on usb uninit...
I need your help to design the radio matching network on device nRF52805.
Here the reference design: infocenter.nordicsemi.com/index.jsp In this reference design L1, L2...
Hi Nordic Team,
My dev environment is as follows:
nRF58232+ ses+ sdk17.0+ softdevice 132
We are using BLE Chip on custom board
When we flash precompiled hex file...
Im working with nrf52833dk to implement USB mass storage using the flash to write into txt file.
main.c code is:
when flash and plug the usb the file storage apeare...
Hello!
My name is Carolina and i am working in my thesis with a multinacional enterprise in Aveiro University The objective is to develop a system like a security system...
Hi Team,
I am not sure nrf52840 chips if they must connect ants so that they can broadcast?
Because I do see the ant on the nrf52840 DKs.
Could you help me?
With...
Hello everyone,
I developed an application that makes it possible to scan devices and retransmit your advertisements. In addition to enabling the connection with peripheral...
Hi!
I'm working with the nrf52840 custom board, porting working project (tested on the ncs 1.4.1) to the ncs 1.7.1. As we are using several board variations for the same...
Hi Team,
I am trying to develop my PCB based on nrf52840 chips. Now I want to know the type of ant(not NFC) used in nrf52840DK as my reference.
Could you help me?
...
I have a custom board like a breakout of NRF52820 with the QFN48 package. The design is according with the reference circuitry without changing a thing. The IO pins and SWD...
Hi Nordic Team,
My dev environment is as follow:
nRF52832(ble central)+ S132+ SES
We are using BLE Chip on a custom board.
When we flash hex file ( softdevice hex...
