Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
It seems that thread has a function to automatically switch channels when the signal is bad.
Suppose when a device in the same thread network is powered down, and then the...
hello Nordic
i am working with nrf52832, on the Central app_ble_blinky axample (with pwm, saadc, timer, app, timer, uart ), sdk 16.0, s132 v7
when running my code on...
Very surprised to not find this in the Marketplace, but can anyone point me to a great sample Github Action for building NRF52 images. My searches are coming up short or using...
Hello
I would like to transmit gps data to my website in addition to nrf cloud, there is a example or documentation about this that I can take of reference? I am working...
Hi I am New with nrf24l01+ and i made my first project it was working perfect with 2 nrf24l01+ without antenna . After the end of the project i change one of the nrf24l01...
I'm trying the given example < twi_sensor >. I connect nRF52 DK P0.26 to my sensor's SDA, nRF52 DK P0.27 connects to my sensor's SCL. My sensor runs at 400kHz, so I modified...
Hello, I'm new for mesh, have a question about the mesh dfu bootloader.
the source device of the mesh dfu shuld be connected to a host. how to assign the uart pin? is it...
I have to integrate a softdevice into an existing nrf52833 SES project. All the documentation I have found isstarting from any of the examples and using GNU Linker instead...
Hi,
I am trying to create an application for nrf52810 soc. I have a problem on selecting board name and the SDK version
I am having nrf52DK (nRF52832 soc) development...
Folks. I developed my own circuit using nRF 52833 and I`m trying to upload a new firmware via SWD interface. I'm not getting connected to the target for any reason. Is there...
Using SDK 17.0.2 and the nRF52840DK, I am setting up SPIM with a memory IC (not actually hooked up though, just looking at the signals on the oscilloscope). This code is executed...
I'm facing a problem with a product I'm developing. The problematic setup is as follows:
Two nRF52832 peripherals (S132 v6.0.0), each notifying on two characteristics...
