Hi all,
I have an application where an nrf24le1 is communicating serially with another processor, using the UART at 57600 bps. I have multiple identical boards communicating...
after flash DFU program into pca10001 board, com3 is not accessible,
www.dropbox.com/.../Screenshot 2014-04-26 15.41.47.png
even after I erase all, and re upload soft...
Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
Hello,
I am using nRF52832 with Temperature sensor using sdk 16 version . I have done buttonless OTAin ble_app_uart example by adding the dfu in it . I can able to update...
Hi,
I meet a hard fault handler issue when initialize the saadc channel. The code is as followed.
When I set the breakpoint at line 22, the debugging process can work...
Segger Embedded Studio V5.20a / SDK13 (file structure from a legacy project) / BLE / ANT+ s332 4.0.5
I am in the process of moving from command line build (armgcc make...
I'm assuming AGPS in the Asset Tracker was designed to use nrf cloud. I don't know if that will be suitable for production deployment at the moment. The GPS with SUPL sample...
Hello,
Our customer want to know how to know the ZR and ZC is lost for a sleepy end device.
I check with the document.
For ZC ,
i fund ZB_NLME_STATUS_INDICATION event...
Given a peripheral with BLE services A and B, if I advertise B but add A first during my services_init code, then the 16 bit UUID portion of B is added to A's long UUID. Is...
Hello ,
I am using NRF 52 DK board and SDK15.3.0 .
I have tested \examples\peripheral\blinky_freertos code and its working fine .
but the same code ( in that code ,...
I have a custom board with nRF52840 (with SDKv17.0.0 + s140_7.0.1). I'm making a BLE peripheral out of it, but it disconnects after 2 minutes. Things seem to work fine during...
Hello,
I have been struggling with managing power consumption of my nRF52832 so it can stay low. I'm using nRF5_SDK_17.0.0_9d13099. I did some extensive search on the available...
Hello All,
I'm updating an application for the nRF52840 that requires it to enumerate and act as joystick. I'm able to run the HID generic example in SDK15.2 on the BMD340...
Target is nrf52832+SoftDeviceS132
When run ActiveScan,
Is SCAN_RSP advertise_report notified only after ADV_SCAN_IND advertise_report?
If I receive only the SCAN_RSP...
