Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
In 15.3, there is a new application type valid for DFU, external app. When loaded through DFU, the program just sits there in bank1, and doesn't get sent anywhere. I'd like...
Hi, I'm trying to use the iOS nRF Mesh Library on GitHub: https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library
I've managed to install the iOS app, but I am unsure...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
Hello,
I was able to flash demo .hex to my nRF52840DKs from this ( https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role ) project, but now I would like to...
I alway used direct UART command with nRF24AP2 and CW test was not a problem.
Now with nRF52xxx and S212 softdevice I try this ... but nothing works .
sd_ant_stack_reset...
I've used Segger Embedded Studio to compile and run a number of example projects -- nicely done!
Now I'm ready to start creating my own projects, with the ultimate goal...
hello,
i'm trying to communicate between a central device and a peripheral.so if multiple peripherals are present and all of their mac id is known.how can i select a particular...
SDK 14.2
i just added peer manager to an existing project, and peer manager seems to be working correctly. pm_peer_data_app_data_store() is successfully called to save addition...
Hi!
I'm currently in the process of evaluating the nRF9160 DK. I'm trying to measure the current of the LTE when the PSM mode it's set. I'm using the at_client application...
Hi team,
My customer found that our SDK15.3 is supporting FreeRTOS version 10, but their original codes are based on FreeRTOS version 9, do we have any guideline which version...
