Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi, i have been converting my keil uVision 5 project to SES. Attached font file works fine in keil but not in SES. Everything else work great as expected. But not the font...
Is there a way to convert the data representation of the BLE characteristic into, say, strings?
Secondly, any way to debug as to why am I seeing more bytes than what i'm...
Which bit of which register gets set upon the triggering of an interrupt? Is there something equivalent to EXTI_PR (pending register) from STM32 which gets set upon triggering...
HI
I have a problem in my code, Have no idea exactly what happening
it is a library.
library.c
library.h
error: unknown type name 'bool'
could you help me...
So we have the SAADC configured to read using timer attached to ppi. We read from 5 adc channels. If we set NRF_LOG_ENABLED to 1 in sdk_config.h all the channels read fine...
Hi,
In first attempt to plug power to micro USB port I got red red LED on (indicating some error). LED is on even without connected battery. Based on nPM1100 documentation...
Hi there I am facing a strange issue nowadays after working continuously for two weeks + with the TWI module. I started off the with twi_sensor example in non blocking but...
I want to use a nRF9160 to send data over UDP/NB-IoT.
For encryption I want to use eclipse/tinydtls in order to have support for RFC7250 and (upcoming) RFC9146. That works...
I would like to use the SLM application for the nrf9160dk. I am having problems compiling the codebase on windows.
Using Zephyrs west with the "west build" command results...
Hello,
I am trying to connect asset_tracker_v2 to my aws iot cloud with MQTT,
then storing this data in aws database, when i changing parameters to AWS Iot library,...
I have made a software serial library for nRF52840 similar to Arduino software serial. It is working fine. nRF52840 has two UARTE instance and one UART instance, As for my...
I've a code that worked fine on nrf52832xxAA chip. I flashed the code to a new chip nrf52832xxAB (less RAM, ROM) and adjusted the scatter file according to sd ble recommendations...
Hi,
How do I get the RSSI of the active ble connection using the nrf connect sdk? I cannot find any examples or documentation.
Thank you
edit:
ok, found this: https...
Hi all,
i'am sending epoch time for example 1641533394 from mobile to nrf52840dk only once ,then i need to update it continuously
so i tried the below link which gets...
