Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I'm new to nordic development, is there any empty template when start developing
that enables ble and twi that just works?
I tried many examples and they all work but...
Hello, I came across this twitter clip by Marjeris showing a Thingy 52 relaying temp info to Alexa. How was this done? by mqtt? or as gadget? thank-you,
I'm trying to port some code from FreeRTOS to Zephyr using a Nordic nRF52840. (I've used FreeRTOS for quite a while, but am a novice with Zephyr.)
I'm using k_poll() (in...
On nRF5340, I need to generate a 5MHz &10 MHz & 20MHz, or 8MHz&16MHz & 32MHz to output for external use, how to do it?
A external sensor needs a continuous 5/10/20 MHz...
Hello, I’m facing these issues with regards to python when starting an nRF Connect SDK Project in Segger: I do have my Pyyaml modules installed but somehow it doesn’t look...
Hello,
I am using nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8.
1. While referring to the Nordic Semiconductor Infocenter . I observed that in nRF5 SDK v16.0.0 there...
Hello
My nRF9160 DK was working fine and it had certificates for AWS cloud. I wanted to update these certificates so I did it but every thing went wrong. Therefore i erased...
Hello,
I'm trying to use hardware acceleration for my ECDHE implementation. With the SDK-supplied functions, this should be pretty straightforward, however, the functions...
Hello Devzone
Currently, we have below USBD application scenario
now the user are using the nrf52820 with disable the USB p eripheral and they have another USB IC connects...
Hi Nordic,
Background:
I am making some changes based on your 2 examples BLE_UART_central and BLE_UART_peripheral to make them talk together with the BLE connection...
I'm use freeRTOS by the nrf52832.But it only 1 channel uart,I need to two channels uart。if analog uart by GPIO,need to us delay.How to generate us delay？
I am debuggin using NRF_LOG over UART. Now I want to implement own UART functionality e.g. to configure the firmware. Is it possible to use the UART for both purposes?
Hi,
I am retaining a buffer for checking whether it is happening the first time after power on or not.
for the first time, I am keeping predefined values(2 for check initialization...
