Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I am using the following
Mesh Version : nrf5_SDK_for_Mesh_v2.2.0_src
SDK Version : nRF5_SDK_15.0.0_a53641a
IDE : SEGGER Embedded Studio for ARM Release 4.10...
Just wondering if anyone knows a reliable method to update a project to use a new SOFTDEVICE version?
One that can be repeated for each new release.
I am using Segger...
Hi,
I have a question about pairing a phone with the nrf52832.
During the pairing phase (the phone see our device that is advertising and then starts the paring procedure...
Hello,
i am facing issue with nRF5x Command Line Tools. I am using custom board with nRF52832. While i am using Segger J-flash Lite there is no problem to flash program...
I am developing a wearable using nRF52832 and looking for best debugging practice. I have given provision for SWD pin connection on PCB board. What is the best suitable JLink...
Dear all,
I'm looking if there is a easy way to add custom commands to the OpenThread CLI without touching the OpenThread core ? I didn't find anything in the API.
Thank...
Hi Nordic team,
I having problem understand TWI_INSTANCE_ID and what are usage of this configuration?
For example, if I were to use 2 different TWI hw port (SCL1,SDA1...
I am using a raspberry pi that is running a NUS service. The PacketList in Wireshark shows the advertising packets from the device, but the device is not showing up in the...
Hello, in sdk 15.2 there is an SES version of radio_test for pca10040, and within main.c, starting on line 121, there is reference to NRF52810_XXAA. Is this to understand...
Hello,
I am developing an application in which mesh client in some cases needs to send consecutive messages to the mesh server. I use a modified version of Simple On/Off...
Hi,
I am trying to modify the enocean switch example to send the commands from the switch to different devices connected in the mesh. Example shows that the a0, a1 control...
I'm trying to create more groups in mesh.We know that all the nodes(servers) are divided into two groups called ODD and EVEN,so I want to create more groups.
I have changed...
I posted recently ( https://devzone.nordicsemi.com/f/nordic-q-a/40381/interfacing-with-mcp4725-with-twi-registers ) and after editing the post, I can no longer access it ...
Hello, boss, I used twi read/write data from others device, I find a strange problem, When in no-blocking mode, mainly loop use "sd_app_evt_wait" TWI can't write data to others...
Hi, all. I have been going through the mesh examples and have been able to do the light switching, dimming etc examples and have used the RTT as well as physical buttons to...
