Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello, I am investigating the possibility of integrating the DTM functionality into our app (which uses the softdevice) to allow us to use a single image for production testing...
Hi,
I am using the SAADC example in SDK 12.2.0 together with SoftDevice (S132, v3) and its working fine without any problems. As a modification, I want to uninitialise...
After calling sd_ble_gap_connect() at an arbitrary time, how does the central actually connects to the peripheral?
Assuming the client probably listens only at certain times...
Hi all,
Is there a way to change the UART pins configuration to bypass the segger jlink debugger on the nRF51/52 devices? I would like NOT to use this debugger chip for...
I am trying to receive a string of 708 characters via BLE. As BLE cap a maximum of 20 bytes per transmission, at the mobile app side I break the data to be send every 20 characters...
Hi All.
I wanna to continue Advertising during peripheral connection due connectable ADV prohibited if Peripheral connection established for nRF52840.
Is it possible to...
I'm trying to print a 20 byte array over uart before sending it on BLE. My array contains:
{0x34, 0x12, 0x00, 0xFF, 0x00, 0xFF, ..., 0x00, 0xFF}
However when I try...
Hi, i am actually working on a smart lock and i want to implement an Automatic Unlock.
This functionnality can be really useful, because the door unlock even if your smartphone...
Does the ACL peripheral protect flash from Read/Write/Erase of CPU and all peripherals? or just CPU? or do some peripherals have a privileged access? (such as the CryptoCell...
Hello,
I'm working on a project that needs sha1 hash functionality and I found this thread about the integration of openssl hmac lib:
devzone.nordicsemi.com/.../
...
Hi,
I have been working with Bluetooth mesh. The test I have been performing repeatedly polls a single node and measures the RSSI (as measured from p_message->meta_data...
Hi,
I purchased Thingy:52 I want to develop ble mesh n/w application on Thingy:52.is it possible that I get any sort of support from you in this context.
I'm trying to run the Thread DFU examples on nRF52840, unfortunately I can't get them to work. On the client, I got the bootloader set up and ready, with the client application...
Hello!
I don't quite understand how to properly link NFC tag library (nfc_t2t_lib_gcc.a) to Segger Embedded Studio Project.
Steps I did:
Add nfc_t2t_lib_gcc.a...
