If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
Hello,
I am using nRF52832 with Temperature sensor using sdk 16 version . I have done buttonless OTAin ble_app_uart example by adding the dfu in it . I can able to update...
Hi,
I meet a hard fault handler issue when initialize the saadc channel. The code is as followed.
When I set the breakpoint at line 22, the debugging process can work...
Segger Embedded Studio V5.20a / SDK13 (file structure from a legacy project) / BLE / ANT+ s332 4.0.5
I am in the process of moving from command line build (armgcc make...
I'm assuming AGPS in the Asset Tracker was designed to use nrf cloud. I don't know if that will be suitable for production deployment at the moment. The GPS with SUPL sample...
Hello,
Our customer want to know how to know the ZR and ZC is lost for a sleepy end device.
I check with the document.
For ZC ,
i fund ZB_NLME_STATUS_INDICATION event...
Given a peripheral with BLE services A and B, if I advertise B but add A first during my services_init code, then the 16 bit UUID portion of B is added to A's long UUID. Is...
Hello ,
I am using NRF 52 DK board and SDK15.3.0 .
I have tested \examples\peripheral\blinky_freertos code and its working fine .
but the same code ( in that code ,...
I have a custom board with nRF52840 (with SDKv17.0.0 + s140_7.0.1). I'm making a BLE peripheral out of it, but it disconnects after 2 minutes. Things seem to work fine during...
Hello,
I have been struggling with managing power consumption of my nRF52832 so it can stay low. I'm using nRF5_SDK_17.0.0_9d13099. I did some extensive search on the available...
Hello All,
I'm updating an application for the nRF52840 that requires it to enumerate and act as joystick. I'm able to run the HID generic example in SDK15.2 on the BMD340...
Target is nrf52832+SoftDeviceS132
When run ActiveScan,
Is SCAN_RSP advertise_report notified only after ADV_SCAN_IND advertise_report?
If I receive only the SCAN_RSP...
