Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
Hi,
I've created an application using the S110 experimental ANCS demo. I successfully implemented ANCS and then began to structure my application around it. At some point...
Hi,
We have a product that uses nRF52832, we are trying to get the FCC Certification. We are using the RF test example to setup the DUT.
We are able to get the signals...
Hi,
I wanted to use Nordi UART service, the problem is that if I have no contraction with the device, it would not advertise after a definite time, say 180 Seconds, my devices...
I'm trying to connect nRF916 FP1 Preview DK to LTE-M network using LTE Link Monitor but it fails. Below is details about my firmware/software:
Zephyr OS v1.13.99-ncs2
...
Hello,
I am currently working on nRF52840 DK while waiting for my custom board using this chip.
This custom board will include Toshiba external flash of family TC58CYG2S0HxAIx...
Please understand that it is English using a machine.
Hello. I try to create a module using nrf52810 and nrf52840. We are testing "secure_uart_pca10040_s112...
Hi,
the bootloader addr is start form 0x28000, and I checked my application code, it only reached 0x25B00.
I called the fstroge to erased a page Flash start from 0x27000...
We going to test the link range of mesh networks (BLE mesh the first and Thread later) inside the building - between the floors.
It's possible the hop between the floor...
Hello,
I’m using nRF51-DK with SDK 12.3 with softdevice S130 (BLE is advertising). I would like to talk with a serial device that starts up with no HW flow control and later...
Hello! I know that there's a temperature sensors built in the nrf52840 device. what i would like to do is to connect an external temp sensors, and get the data from it in...
Hi,
I want to use AES CCM in my project (I want to try both CC310 and mbedTLS).
When I compile my project, I have undefined reference to 3 functions that are located...
We have a 52832 device that is showing some possible flash corruption during programming. Does the softdevice perform an integrity check on startup such that a corrupted softdevice...
