I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hi
How many bytes of data can be written to flash memory at a time? I am trying to write an array of 10 elements of 16 bit data type , but only the first four elements are...
Hi,
I was wondering if a central can perform multiple read requests with authorization, i.e. send a read request before it has received the reply to the previous request...
Hi,
the system we are using includes the nrf52832 SoC with an external ADC and en external crystal for HFCLK. running SoftDevice s132 v2 (based on SDK 11)
in our system...
I like to program NRF52840 Dongle without using NRF Connect Desktop (i.e, Normally we develop application program using some IDE) Can i develop application program using NRF52840...
Hello everyone
I started working on BLE devices recently and I have an Ardunio with BLE 4.2. However the maximum data rate seems to be low for my purpose ( about 60 Kbits...
Hi Guys,
I have been trying to port the older nRF51 debouncer_example (attached) into the nRF52 SDK15.2 ble_app_template example with not much luck. I realise that this...
Dear nordic,
1. Is it possible to create thread networking using dongle?
2. I want to create Thread CLI example in dongle but the problem here is UART pins and LEDS. what...
hi ,
I'm a newer , using nRF5_SDK_15.3.0_59ac345. we are using nrf52832 to get about 100 of heart rate sensors.
so first we do a scan ,and get all of there addrs. and...
Hi Dear
We plan to implement our own DFU controller on host MCU, the bootloader+softdevice+app zip file will be generated by nrftutil software.
How to exact those part...
The Capacitive Sensor low-level library documentation says:
Note:
Until Anomaly 84 (ISOURCE not functional) is fixed, the COMP solution cannot provide production-level...
Hi.
I usually used nrf52832 rather than nrf52810 since nrf52832 has an FPU, I rarely considered the computational cost for calculating floating point.
The problem is,...
