Hi,
My android Proximity application fails on service discovery only for the very first time it connects with the devices(nrf51822 evaluation kit with sdk 5.2.0). Actually...
Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hello sir,
I have completed PCB design of custom nRF52832 board. Can i use following component instead of recommended part No in reference design. I have also mentioned...
Hello ,
I would like to design a custom board with nrf52832 IC and CP2102 for communication with PC serially. Unfortunately nrf52832 doesnot have Rx/Tx pins for interfacing...
Hi community,
for our application (nrf52832 / SDK 12.2) we need to store data received via BLE. The received data is a 25 kB binary blob which by design will be chopped...
Hi,
i am checking NRF52840 for USB behaviour.
I'm using example usbd_cdc_acm.
But USB receiving stucks after few bytes (between 0 and 50) and does not receives nothing...
i have nrf52 dk i run simple examle saadc from sdk 12.1.
now i want to get result.
i can't understand the code.
i start putty terminal adc event number and app info number...
I'm having trouble adjusting ram start setting using the new SES projects from latest SDK14.1.0
I have tried the project linker section placement macros settings of
...
Hello, is it possible to use a wire antenna with nRF52832?
I have read that only PCB or chip antennas are used, so I expect the answer to be no, just wanted to confirm...
Hi Nordic Engineers!
I read the description of new SD s140 v6 and find a lot of good features.
A question 1, is this the next version that will be supported in the future...
HI，all
In normal circumstances, ios phone paired and connected to my 52832 device, when they are disconnected, ios phone can automatically reconnect the ble device. But sometimes...
Hello ,
I want to use the Button with Height level to trigger.The default is Down level to trigger.What should i do for that ? I try to set BUTTON_PULL NRF_GPIO_PIN_PULLDOWN...
Hi,
I have just added over the mesh bootloader updates for my mesh and I am curious about the MBR parameter page. I want to use that page as a swap page in my application...
I set the NRF_LOG_BACKEND_RTT_ENABLED 1 and NRF_LOG_ENABLED 1 in the bootloader and application.
After a reset, the application gets stuck in the bootloader
Or maybe (bl...
