Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Can anyone please help me on this? I struggling in transmitting string and numbers from nrf51822 to mobile app through BLE. I need some sample code. thanks.
uint8_t numbers...
Hi, In my project I am using nrf51822 device and I need to perform dfu operation,for that I am using soft device s110 and boot loader nRF51_SDK_9.0.0_2e23562\examples\dfu...
hi
i follow "Development with GCC and Eclipse" in tutorial to Create a new Eclipse project step
i got some problems
it says " type XXX could not be resolved"
it may...
Hi,
I have 2 pins that connected to transistors that turn on high-side FETs. One turns on 3.3v for the rest of the system and another one 4v.
When I turn on 3.3v everything...
hi. I want to work with nRF8001 by STM32F103 family from ST.( www.st.com/.../LN1565) is there any one who develop a project with STM32F103 by using STM32CubeF1 ( www.st.com...
I am having some trouble sending DFU to my development board through the iOS app.
When I prepare a zip file for the nRFToolbox app, I include the .dat and .bin files in...
I'm able to run my applications on SDK 9 with softdevice 130 with the development kit. The chip on it is labeled N51422QFACA11503AD. I have a custom board that has a chip...
Hello everyone ,
I have written the program for getting the buzzer Beep sound and then i compiled the program without any errors and warnings but i am not getting the beep...
I recently grabbed the latest SDK nRF5_SDK_11.0.0-2.alpha. I was looking at some of the changes and wanted to run one or two demos to make sure I was able to build them properly...
