Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
Updating the nrf-sdk from 2.1 to 2.2 breaks the networking in qemu.
All details including a minimal example to reproduce this issue can be found in the github issue:
github...
Hi There,
Is there a chip in the Nordic family that supports both Ble and Wifi ? , it does not necessarily have to be concurrently but having the ability to switch from...
I am running the 5340 audio example on three dev kits. My goal is to have the gateway to act as a peripheral and a central so that the device can connect to the two headphones...
Hello, guys!
We are using nRF51822 SoC with nRF5 SDK v12.3.0 and s130 SoftDevice. For the devices in the wild, we would like to implement the following health monitoring...
I am having some trouble adding support for firmware updates to our product, for the application as well as the net core and the secondary bootloader . Chip: nRF5340 SDK:...
Hello,
I want to store 18 * 200 bytes of data in flash. I am using fds for storing the data. 18*200 comes around 3600 byes.
FDS_VIRTUAL_PAGE_SIZE = 2048
FDS_VIRTUAL_PAGES...
I'm creating a CIG with two CIS each carrying 240 byte payloads. It worked fine with NET fw 3303 but has stopped working with NET fw 3307
* 2 CIS with 120 byte payload works...
Hello,
I would like to perform DFU over mesh and unfortunately nrfutil is missing modules
I am following: https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
hello everyone , I have a problem that I can't solve, this is my need: -my device is a battered BLE peripheral and it needs to generate an advertisement every 4 sec. It needs...
Visual Studio often refuses to run the debugger because the dev kit will disconnect suddenly during the flashing process. The same happens when I tried with Keil uVision before...
Hi everyone, I'm notice that there a way to increase the range of Bluetooth mesh network by using the LN/PNA module.
I'm currently want to have this module implement on...
I am completely new to the Nordic chips. I have some knowledge with programming and creating a pcb for the ESP8266 and ESP32 but for my new project they consume too much energy...
Hello,
I'm trying to create a single shot PWM pulse. So I short SEQEND0 to task_stop. I setup an interrupt on stop event.
It works and enters the IRQ handler. I tried...
Hello,
I am using an nRF52840 on a custom board running the BLE stack from SDK16.0.0. I have an application that periodically advertises for 10s and is idle in between these...
Hi,
I'm using nrf9160 custom board i want use both uart1 and uart0 but when i use both uart's uart1 is not working,
I have already created for this issue but it been almost...
