i'm writing bare-metal code for the FLPR (which was loaded by a bare-metal launcher running on the M33)....
when my FLPR code "idles" using the WFI instruction, power consumptions...
I want to use the Softdevice Controller without a crystal on the RTC. I configured my project with
Advertiements look fine, but interaction with a BLE central either throw...
Hi everyone,
These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
I am planning to use 3.7V non Rechargable Battery with Diode and Reverse Protection circuit with npm2100, Would like to build a Fuel Guage model for this as this is not available...
Hello,
I am currently evaluating MCELL location on an existing project, based on nRF9160.
After some trial and errors, I managed to get it working.
However, I ma a bit...
HI
I am currently using the nRF54L15 chip with NCS 3.2.1, carrying out secondary development based on the periodic_sync_conn sample project. I intend to adjust the transmit...
Hi,
We are developing an application that requires synchronization between two or more nRF9160-based devices. We have the following requirements and constraints:
Required...
fota_download_start copies the file but not host string into a static buffer. The comment implies that the download_client only requires this for the file path, though it...
Hi everyone, i have some problems with firmware and i hope someone can help me. I am using nRF52840 microcontroller and SEGGER Embedded Studio. Also I'm using the littlefs...
Hi ,
I want to use a pin on board, which is not used or initialized in dts file . my requirement is that I want to initialize that pin before booting process. ( that pin...
Hi,
I am using the :
bt_scan_filter_add (BT_SCAN_FILTER_TYPE_MANUFACTURER_DATA, &mfgData);
scan-filter works well.
However, keeping everything same, if setting...
Hi,
I have been working on the display from JDI LPM027M128C with the nrf52840 development kit. By consulting the datasheet of the display, it seems to work with the spi...
hi :
can you help me to solve this problem. The path of the example is bellow：
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fsdk_nrf5_v17.1.0%2Fexamples.html&cp...
Hello,
I am trying to work with the MCUBoot bootloader in my project. I was able to configure and build my project and it appears to run properly when I flash it to the...
I have a nrF52840-DK and would like to try some precompiled test, but I got an error when copying a hex file to it. The error message is that The currently active SWD interface...
We need to store a .fw firmware (or any binary/hex) image for an external device hanging off the nRF52833 in internal flash. What is the best way to integrate the image into...
Hi
after install sdk of nordic( Installing manually — nRF Connect SDK 1.9.99 documentation (nordicsemi.com) ) on ubuntu 20.04 LTS, when run EmbeddedStudio, i got the message...
Hello all,
for the last few weeks I am trying to workout the i2c protocol with the sensor and the nrf52dk , so far none of the solution that I have considered work. More...
Hi,
I upgraded to the newest SDK and now our SPI Code (RFID Reader) is not working anymore. Is there something that changed with parameters or anything else? If I step back...
