We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
Hi
After each connection, I should press Alt-A.
Is it possible to add a feature so the advertising will restart automatically after the connection is finished?
Hello Support Team!
I use nRF52840 and migrate to nRF5 SDK 17.1.0. But I can't use Trace functionality, because SystemInit method from system_nrf52.c file use wrong pins...
We are facing the problem that when relay feature is enabled on a mesh device (which is running nRF Connect SDK firmware), device response is delayed in a range of seconds...
I have been working on an application for the nRF5340 using version 2.1.0 of the SDK, and it includes a task which collects audio data using the DMIC driver. After adding...
I have written code based on Bluefruit nRF52 feather board in Arduino IDE. I need help to know is it possible for me to flash same code to my custom board based on nRF52810...
I am trying to get familiar with matter, and have the following two devices:
- Thingy:53 flashed with the matter weather station example ( https://developer.nordicsemi.com...
I need to send broadcast leave request to all the zigbee devices connected to the network.
zdo_mgmt_leave_req function sends leave request to a particular device but we...
We have a custom bootloader and need to set a different start address in Flash for the entire image (merged.hex)
For an earlier version of nRF Connect SDK (v1.4) this was...
Hi,
I have four Thingy:53 devices. I can get all the Bluetooth Mesh light and light switch demos to work without problem .
I would like to test and demonstrate relaying...
Dear Support,
We just discovered the hard way that the LTE link controller of NCS 2.2.0 uses the AT monitor. This is an important change compared to earlier NCS versions...
Dear everyone,
I am exploring embedded development with nRF products. In particular, I am trying to setup projects both in pure Zephyr and nRF Connect SDK (NCS) to see which...
I would like to exchange information via CoAP between my thread end devices and a CoAP server (IPv4) on the internet.
The current Setup: nRF52840 --> Border Router (RPi...
Hi,
We use nRF5 SDK v17.1.0 for custom application (bare-metal / without os). We are trying to port littlefs for External 2MB FLASH connected via QSPI.
Please let me know...
We are evaluating a product that will run as a Thread end device on a embedded Linux system. (with only Thread as interface, no wifi/ethernet)
We are today using the ot...
I have a custom board with the same hardware configuration than dongle pca10059. This board has the same bootloader than the dongle but I need to upgrade the firmware in a...
I am looking to develop a Speedometer using a GPS module (ublox) with the nrf52832. I want to parse the data and calculate the speed using GPS coordinates. I was wondering...