Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
HI
I had some great support in t his ticket so I will try my luck again.
We want to migrate our application from SPM to TFM. We use SDK 2.1.0. We communicate with the...
Hello to all I am quite lost, I need help to connect an oled to my project. The rest of the stages I have it complete, but my experience with OLED, is limited to arduino with...
Hi,
I am looking for help, we are moving to the 3.2 of zephyr. All our projects are custom boards that run on the previous zephyr version (2.5).
When we compile our...
We use nRF9160 with our board (with Serial LTE Modem 1.9.1). We try to download SLM / Modem firmware via nRF Cloud and we ran into several problems/misunderstandings: 1) First...
Hello,
I can get the distance between four NRF52833 device based on the distance measurement toolbox SDK 1.9.1, but the output rate is a little slow, less than 1 Hz. And...
Hi,
I have a custom board based on nrf52811 and nrf9160. So basically I want to flash those 2 custom board. But I only have ST-Link v3. After doing some research, I only...
Hi Nordic team
I work with 2 NRF5340-AUDIO-DKs (LE audio) and now switch to custom HW on the sink side. Since we only need 3W stereo output we work with 2 MAX98357A
We...
Hi Nordic team
According to this post I eliminated all calls to cs47l63, ina231 max14690 pmic in order to migrate the project to my custom hardware.
After that I get the...
The NRF9160-DK is not recognized for programming Thingy91 by the debug port P19 after Nordic tool and J-Link firmware update from 3.10 to 3.12.
It showed error on VSCode...
Hi,
my board is configured for working @1V8 so I do expect that nRF52832 OB J-Link doesn't work for programming it due to the fact that DK can work @3 / 3.3V only.
I...
Hello, I am using Nordic Power Profiler Kit II for measuring the consumption of a DUT (average 50mA + peaks) but the value returned is completely wrong. I compare the value...
7488 111.881 Slave_0xc844ed5f LE 1M SMP 6 151µs 1 0 True 1 Rcvd Security Request: AuthReq: Bonding
Apparently the SOURCE was the 'slave' but the message was a 'received...
Hei,
I am trying to add mcumgr support for my bootloader. I simply add these configs to mcuboot.conf file:
CONFIG_MCUMGR=y
CONFIG_MCUMGR_SMP_UART=y
CONFIG_THREAD_MONITOR...
Hi,
According to this link: https://learn.microsoft.com/en-us/azure/iot-central/core/concepts-device-templates , IoT Central can automatically assign a device to a device...
I am still trying to figure out what NVIC_SystemReset actually does and why a build and run always gives an error forcing me to press the reset button on the DK to function...
