Hi, I am fighting with a bug I found in SDK v2.8.0 for BLE scan filter on a test project as follows: 2 Devices (Ezurio BL653-DVK using the nRF52833), both having central and...
Hi,
I am a newbie and just strted first evaluation with nRF52832 board. I am using SEGGER IDE.
The example i am using is: C:\nordic_semi\nRF5_SDK_15.3.0_59ac345\examples...
I am trying to use the Watchdog on the nRF52840 as a means to check state of the application via different variables. If I see the application in a bad state, I would like...
Hi all,
I have a trouble about understanding.
As far as I understand, when Device 1 send service change indication to Device 2, Device 2 will rediscovery service of Device...
it seems that SDK 15.2 is missing the uint64_t cast for the reload_value calculation again.... or am i missing something? we use a 5 minute value, which does not work unless...
I try to DFU operation.
SDK15.3.0 / GCC / nrf52840
My application image size is 123,484bytes (nrf52module.bin)
I run command ,
nrfutil.exe pkg generate --hw-version...
Hello All,
I am working on nRF51822 using IAR IDE and nRF51 SDK 12.3.0.
Right now I am checking power consumption of device in ideal mode but right now it is higher. ...
Hello. I tried to understand MMA8652FC Acceleration sensor with 52832.
I don't know what means 16Hz, 8Hz, etc. under table.
I know just concept of High pass filer. that...
Hi, I want to use wolfssl library on nrf51822 and I'm in stuck.At first, I compiled wolfssl as arm-none-eabi ,then added the static lib to the project in segger studio.
...
Hello everyone!
I'm trying to build a project of gathering the information from several temperature/pressure/humidity sensors and sending it to one display.
Sensors will...
Hi, I've tried to set BLE power to max but an app error is raised when I use the sd_ble_gap_tx_power_set function. Parameters should be wrong but as far as I've read over...
How do I align UART transmission/reception with GPIO pin signaling low/high? I wanted to do this because BLE chip is receiving the Product ID & device name from microcontroller...
Hi there,
I was used IAR to compile my source, and combine with bootloader and soft device, and it was always work fine.
Now I have changed my compiling tool to SES IDE...
