I'm using the nRF Connect SDK on nrf5340dk and encountering issues when trying to use the non-blocking (asynchronous) I2C API.
i am particularly getting this error - ENOSYS...
Hello everyone
I'm currently trying to make dynamic endpoints on my matter device. I changed the .zap file to accomodate all the possible endpoints (16) with clusters...
Hi community,
I have a similar custom board as Thingy53, which has the nrf21540 module on board.
my purpose is to turn on the nrf21540 and do the reconnection, when...
Hi!
With the release of NCS 3.0.1, the required SEGGER JLink version to v8.18. pynrfjrprog is bundled with SEGGER JLink v7.94. From your website, it seems nrfjprog, being...
Hello,
Over the past three days (up until today), we've observed inaccurate behavior in the Message Routing Service. Specifically, we shut down our destination service during...
Hi,
I use the nRF54L15-DK flash fimware (.hex) with "nRF Connect for Desktop - Programmer" success.
And I view the schematic, discovered the DK board have flash memory...
I have a NRF9160 design with a TPS63031 regulator providing 3.3v. When my battery gets weak I am seeing spontaneous reboots, likely due to input voltage droop.
I'm experimenting...
I would like to hide BLE advertising from normal BLE scanner software.
And only be able to see such advertising with dedicated scanner.
I was thinking of changing access...
There have been a couple of questions asked that are similar to my question but in the interest of getting more clarity I am asking a new one as others have had accepted answers...
So, I open a nRF51 project today and found out that it failed to build. Turns out my uVision lost all of the target devices in its list, leaving only STM32 F0 and L0 series...
I am trying to download the examples from NordicSemiconductor/nrf51-ble-tutorial-advertising
The link shows:
github.com/.../main.c
but when I click on it, or right-click...
hello,
i am uing nrf51822.now i am in trouble while running uart on nrf51822.please tell me which can i have to burn on nrf51822 for getting uart properly working.i am using...
Hi,
Is there any information on how much improvement the DCDC has over the LDO at 1.8V? I'm working on a heavily space-constrained application, and I'm trying to make a decision...
Hi, i am working on PWM Library example in which i a m configuared GPIO pin P0.25. then i am getting voltage variations 1.3 to 2.8 volts.
the problem is when i disable...
Hi,
I want to connect old nokia 3310 to NRF52 DK.
Please let me know if any one has information about it?
Based on my research old nokia phone uses M bus and F bus...
Hi,
We're working with very specific hardware which requires us to watch very closely. We're currently considering a blocking function in an ble event handler which can...
Hi all,
We are currently developing a BLE enabled sensor device. We want to use the NFC component to identify the sensor by writing a device ID to the tag.
Question...
Hi,
The comparator (COMP) in nRF52 can use three internal reference voltages (1.2, 1.8 and 2.4V). Is it possible to also output these voltages on IOs?
Best regards
...
hello there in my code,
APP_ADV_INTERVAL 64
APP_ADV_TIMEOUT_IN_SECONDS 5
using nrfsniffer i am getting 57 packets in 1 second.
i can't understand it. because APP_ADV_INTERVAL...
