Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
why use 50ms and 400ms connection interval for testing the maximum data throughput(2M,247byte payload)?
Because 50ms can only send a pdu , and 400ms can send up to 8 pdu...
In 15.3, there is a new application type valid for DFU, external app. When loaded through DFU, the program just sits there in bank1, and doesn't get sent anywhere. I'd like...
Hi, I'm trying to use the iOS nRF Mesh Library on GitHub: https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library
I've managed to install the iOS app, but I am unsure...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
Hello,
I was able to flash demo .hex to my nRF52840DKs from this ( https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role ) project, but now I would like to...
I alway used direct UART command with nRF24AP2 and CW test was not a problem.
Now with nRF52xxx and S212 softdevice I try this ... but nothing works .
sd_ant_stack_reset...
I've used Segger Embedded Studio to compile and run a number of example projects -- nicely done!
Now I'm ready to start creating my own projects, with the ultimate goal...
hello,
i'm trying to communicate between a central device and a peripheral.so if multiple peripherals are present and all of their mac id is known.how can i select a particular...
SDK 14.2
i just added peer manager to an existing project, and peer manager seems to be working correctly. pm_peer_data_app_data_store() is successfully called to save addition...
Hi!
I'm currently in the process of evaluating the nRF9160 DK. I'm trying to measure the current of the LTE when the PSM mode it's set. I'm using the at_client application...
Hi team,
My customer found that our SDK15.3 is supporting FreeRTOS version 10, but their original codes are based on FreeRTOS version 9, do we have any guideline which version...
