-> How to transfer data from one thingy52 device to another thingy52 device. If i have 2 thingy52 devices, I'll send data to 1st tingy52 then 1st thingy52 device will send...
Hi,
I am trying to use nfc_t4t_lib and I have some issues because processing incoming data takes some time (around 100 ms) and therefore sending the response occurs late...
I'm not sure if this is the right place for this question.
I'm using the Settings subsystem for the BLE name.
When BLE is initialized inside matter, settings_load is only...
Dear devzone，
Based on ncs2.9.1 and nRF54L-DK(v0.9.2), add in the prj.conf of the peripheral_uart example:
Compile and burn to nRF54L15-DK, the program does not run, and...
The nRF54L series is a new device to the nRF family, and during the bring-up of the chip from early engineering samples to mass production devices there have been quite a...
My application uses SDK 11 and s130 on an nRF51822. In certain cases I want to delete all my bonds and go into sys off.
I presume that when I call pm_peers_delete() , that...
I am not clear on what is failing to open here. Anybody have any tips.
(This is on windows)
C:\projects\CB\app>nrfutil dfu ble -f -pkg _build/careband.zip -n test
Please...
Hi Nordic,
I am trying now to create a star network, in which the central node is master of different slave channels. The idea is to configure and open different independent...
Hello,
I'm using the ble_app_uart_c as an example for a Central application. After writing to a characteristic in a peripheral I expect a notification back from that node...
I have a main loop in my application like this:
while (true)
{
// Other calls left out here.
app_sched_execute();
err_code = sd_app_evt_wait();
APP_ERROR_CHECK...
Hello,
I am new to the nordic's controller. We are planning to evaluate the nRF51/52 for our IOT application need.
I am more interested to know the possibility to have...
Hi,
I'm using the button event handler code on the SDK. It fires once when pressed down, and once again when i release the button. How do i make it only fire once per push...
I have two nrf51822AC mcu chips that are integrated on custom boards, and I need to communicate between those two chips (one set as a transmitter and the other as the receiver...
Hi,
I own company that builds a PIC 8-bit devices, and can code at a low bit level in the PIC environment.
I picked up the NRF52 Dev board, and am trying to learn the...
My peripheral device connects with central one very rarely. I decided that I don't want peripheral to negotiate connection parameters with central, just use settings imposed...
I'm developing custom board of nrF51822 CEAA (256k, 16k)
I set my bootloader ROM, RAM just like below
as I understand,
Firmware size should not larger than...
hi,
i just ask about nrf52832.
im using it with keil compiler and trying to divide the memory section (it that will be update and not)
but i have hard time to do with keil...
I'd like to log some debug stuff to a mobile app over BLE, when in a connection, using the NRF_LOG library and the Nordic UART service. I have this working just fine without...
I'm trying to write to specific address on flash memory (data region) for debug purpose using
nrfjprog.exe --memwr 0x3B820 --val 0xAA000000 --verify
but when I read...
