It is good practice to prefix the includes from one's C libraries with a directory so that they are all part of the same 'include namespace'. Unfortunately the Nordic SDK...
Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
I seem to get error 4 on nrf_sdh_ble_enable when building and running the application in release mode.
Everything works perfectly when building in debug mode and I've checked...
Dear Ladies and Gentleman
Regarding the Bluetooth SIG Qualification the BQC needs a QDID for the Softdevice Controller Subsystem ( from table 2 of the compatibility matrix...
when i debug samples in Zephyr, i can see log through UART when i use "printk" function.
but i find there has "BT_DBG" and "BT_WARN" in code. so what's its using? and where...
i am receiving some packets so i need to send that packet to central device(mobile) if i send 20-20bytes it successfully sending the data to central device(mobile) if its...
Hi, i am new at nordic. I am working with nRF connect sdk. I am trying to run example applications but the code never runs. I have checked with debug and it never goes to...
I'm using NRF Connect SDK 2.1.0 and a 52840DK. In normal (non-bootloader) mode bluetooth initializes fine (bt_enable succeeds). However, when I start using MCUBoot, bt_enable...
We are experiencing connection issues for specific Android & iPhone but not for others (i.e. Samsung Galaxy S9).
Phones with issues
Android Details
Samsung Galaxy...
Dear,
I have 2 kits nRF52-DK and nRF52840-DK. I want to make simple app for sending data from one kit to another. Is it possible to use only the radio without using BLE...
Hello guys, i currently applying the example about MPU9255 following this: GitHub - Martinsbl/nrf5-mpu-examples
i'm using the app_mpu.c, app_mpu.h, mpu9255_register_map...
Hello,
Just starting off with Nordic hardware and have some basic questions, first my setup:
nrf52840-dk development board
nRF Connect v2.1.0 SDK
Setup to use 2...
Hi all,
I'm trying to turn on the increased voltage for the +3 dBm transmit power. I understand that to do that, I need to set the VREQCTRL register, or associated bit in...
I just tried updating nRF Connect for Desktop from v3.11.1 to v3.12.0. I did not see an option to update, so I uninstalled v3.11.1 before I installed v3.12.0.
I notice that...
