I am using nrf sniffer for trouble shooting. But it always exit unexpectedly. Wireshark was still open but the DOS window got closed.
I am attaching the log.txt.
log...
Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Does nrf 52840 have an inbuilt temperature sensor? I am getting some values when i see them through hercules software, so are these garbage values or internal board temperature...
Hello, I am developing a BLE application using nRF51822 on SDK 12.3 and SD 2.0.1.
I have an application with NUS service, in which I set the device name by sd_ble_gap_device_name_set...
Hello, I would like know if it is possible to play a buzzer using the Low-power PWM Library ? I am using the nrf51 DK and Softdevice130. The SDK I use is version SDK V 12...
Hi,
I just had a quick question - currently I'm using standard drive mode for everything, however in one case I'm driving an IR transmitter that could really do with a...
Environment: Ubuntu 18.04 Desktop with GNU ARM toolchain (gcc-arm-none-eabi-7-2018-q2-update), nRF5X SDK (nRF5_SDK_15.0.0_a53641a), nrfjprog , J-Link device and PCA10056 ...
Hi,
Device should run clock without stopping.
So one of RTC should run.
And device will run NUS peripheral.
In such conditions, i know that i should not use sd_power_system_off...
Hi, I am trying to develop my own board with on board nrf24L01+ coupled with ATMEGA328p . I want to know if there is any schematic of the same in EAGLE or if you have the...
Hi, I try to read data from the ICM20948 IMU with I2C from my nRF 52840 DK.
Initialization of the device is correct, the IMU ID is sent to nRF correctly which means that...
Hi I am working on nRF52832 board.
i am using fds library to store my data. data contains MAC address. Each MAC address is stored in each record with same file ID and key...
Hi ,Sir:
We have a smart pen coming to market, but we have a problem with directed adv(based on SDK14.2 ble_app_hids_keyboard ). The problem is following:
when the pen...
Currently, we are developing power-saving firmware using nRF 52 Development Kit (for nRF 52832).
I wrote Nordic's SDK and executed it, it was a measured current of about...
