Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hi,
Device should run clock without stopping.
So one of RTC should run.
And device will run NUS peripheral.
In such conditions, i know that i should not use sd_power_system_off...
Hi, I am trying to develop my own board with on board nrf24L01+ coupled with ATMEGA328p . I want to know if there is any schematic of the same in EAGLE or if you have the...
Hi, I try to read data from the ICM20948 IMU with I2C from my nRF 52840 DK.
Initialization of the device is correct, the IMU ID is sent to nRF correctly which means that...
Hi I am working on nRF52832 board.
i am using fds library to store my data. data contains MAC address. Each MAC address is stored in each record with same file ID and key...
Hi ,Sir:
We have a smart pen coming to market, but we have a problem with directed adv(based on SDK14.2 ble_app_hids_keyboard ). The problem is following:
when the pen...
Currently, we are developing power-saving firmware using nRF 52 Development Kit (for nRF 52832).
I wrote Nordic's SDK and executed it, it was a measured current of about...
Hi
I use nRF52832, SDK13 and S132 to develop peripheral which connects to smartphone.
Then I have to do a feasibility study that the peripheral can plays beacon role...
Folks,
This is probably a C question as much as Nordic, so I might be told this is off topic. That's fine if so, I can try Stack Overflow.
I never use macros in my C code...
There is ble_gatt_db_srv_t structure type defined in ble_gat_db.h. It has a field named charateristics. It should be characteristics. Is it going to be corrected or it will...
Hi, Suddenly I can not connect to my nRF5280 PDK (PCA10056 0.11.0 2018.3)
1. I tried using JLinkExe and also SES, the same result, I got error "Can not connect to JLink...
Pins are denied to work as GPIO after the TWIM "Initialization -> Deinitialization" cycle.
After deinitialization, respectively, disable pins from the periphery, using the...
