After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
Hi,
I'm using the LSM6DS3 IMU using SPI.
I am able to read the WHO_AM_I register and retrieve the correct data with this code based on the spi example from the SDKv14...
Hi
Firstly i am coming from 8 bit world(PIC and Arduino) and not so good at c programming. ( just writing all code in main and sometimes using function) (not even use pointer...
Hi.
I want use the synthesized LFCLK.
But sdk_config.h has the 3 items about LF clock source
- NRFX_CLOCK_CONFIG_LF_SRC
- CLOCK_CONFIG_LF_SRC
- NRF_SDH_CLOCK_LF_SRC...
Hi all
nrf52840 Development board,sdk is nRF5_SDK_15.2.0_9412b96 ,PC is windows 10
I have some doubts about bonding,the parameter about PM_PEER_ID_N_AVAILABLE_IDS and...
Hi, latest SDK15. Running BLE_UART example on devkit evaluation board.
Budget Lenovo Android phone will discover BLE device.
iPhone X will not discover BLE device...
How to configure a node for control model. I have used light switch on/off template to implement a control mode but i i don't know how to make a control logic for client....
Let me preface by saying I'm pretty new to working at this low of a level. I'm running a pretty simple program that is toggling a pair of pins once every half second. The...
Hi,
I'm using SDK 15.2.0
I need to measure the voltage in AIN3 and I would like ot know what is the difference between ADC SAADC and SAADC legacy layer.
The system...
Hi,
I am trying to set up SEGGER Embedded Studio for ARM and run secure_boot project.
All the time I have "Project load failed Reported error: solution load command failed...
I have downloaded the motion_driver_6.12 for Nordic Thingy 52. And I am using Segger Embedded Studio to build and debug the code. But the IDE is unable to find the libraries...
Hello Everyone,
I am using nRF52832 with Softdevice S132 v5.0 and SDK 14.2.
I have been using ble_app_uart application as a starting point with SES. What i need now is...
Hi all,
I'm trying to learn more about the pairing and bonding procedures in the SDK. I connected one nRF52480 DK to my computer (running Ubuntu 16.04) and let nRF Connect...
Hi everyone, I have a nrf51822 Bluetooth chip that control a stepper motor, this Bluetooth chip can be powered by a maximum voltage of 3.6V, but I need a higher voltage for...
