I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
Now I use nrf52810 to develop a device, and now I want to use SD_ power_ system_ Off (); turn off the device, and now turn on the device again. What can I do to achieve this...
In the instructions for setting up a project in Segger Embedded Studio it states...
Select File > Open nRF Connect SDK Project .
To import a project into SES, you must...
Hello,
I encountered a problem. When I turn off app_timer during timeslot interruption, it cannot generate app_timer interrupt code show as below:
I am using app_timer2...
I have an application which is currently using a the custom RADIO_MODE_MODE_Nrf_250Kbit mode, and I want to port it to the 52840 and 52911 using
RADIO_MODE_MODE_Ble_LR125Kbit...
To the kind attention of Nordic support team,
I'm very interested in understanding how to have firmware that is working as in PCA10059 in respect to USB bootloader and fw...
hi everyone
I'm new for mesh. having read the document,but have some question.
1 Could the mesh DFU bootloader update the source devices' application through its serial...
Dear all and Nordic Staff:
Thanks for your support as usual.
I have a new application project with BLE and Zigbee dual stack protocol for industry market.
May you suggest...
One of the nRF52840-DK (PCA10056 v2.0.0) we are using as a programmer and debugger for our custom board has started repeatedly resetting the custom board whenever an RTT console...
ble_gatt_db.h and ble_db_discovery.h each contain #defines that are problematic, BLE_GATT_DB_MAX_CHARS and BLE_DB_DISCOVERY_MAX_SRV respectively.
Of course, one can change...
We use NRF52832 in the remote control of the car。 We measured the average current of power consumption at about 1uA.Every 300ms, the current curve bounces to the transient...
I would like to use the RTC in the nRF52833 as a clock-calendar. The device will normally be powered by the USB Vbus but must have power fail protection to insure the integrity...
Hello,
I would like to create a star network (with no routers) in ZigBee with nRF52 (also with multiprotocol BLE). I examined the relevant SDK (nRF5_SDK_for_Thread_and_Zigbee_v4...
