i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
When using nrf51-ble-driver_win_0.3.0 with Visual Studio 2010, after I put a breakpoint in my code, when I try to have the process "continue", I always get unandles exception...
Hi,
we've developed and produced a nRF52832-based custom PCB with custom firmware that is using advertising, scan, connection, custom Bluetooth service and characteristics...
Hi there,
I am designing my own custom nrf52832 PCB and would like to have my design evaluated before put it to production. I am just wondering if Nordic Semiconductor provides...
I am running SDK 15.2 on an nRF52840. I have programmed my secure dfu bootloader, application, settings.hex, and softdevice via jtag. During the first run after programming...
Dear fellow developper,
I'm trying to create a BLE device using HID service to control music, volume and so on.
I have successfully implemented a keyboard + Consumer...
Hello,
I would like to know if anyone else has faced this issue. Indeed, if i want all the consumer control interpreted in the right way, i need to add a keyboard in my...
I'm working on a project with nrf52840 and i'm trying to send and receive ipv6 packet throw thread protocol so i tried to use to send with otIp6Send and receive with otIp6SetReceiveCallback...
Hi,
We are currently working on a project involving a few Connectionless BLE advertisement transmitters based on nRF52832 (SoftDevice 6.1.0). On the receiving end we have...
Hello
I m hardware designing engineer in Turkey.
I m designing bluetooth controlled lighting armature. it must be connect other lamps. And must controlled by phone ios...
Hello all,
I got the nRF52832 dev kit and have been playing around with it. I am using Segger Embedded Studio V4.12. I tried out the ble_app_uart and the writable_ndef_msg...
Hello! I used the "blinky_rtc_freertos" example and transferred ticksource from RTC to SYSTICK in "FreeRTOSConfig.h". The application has stopped working. What am I doing...
Hi Every one,
In my application i want to use two UART's simultaneously, for that i am doing continuous switching of UART communication pins.
I am able to communicate...
Hello,
I am trying to designe my own iot sensor board with nrf52840
For my sensor board i will just add lipo charger IC and MPU6050 (accelerometer)
When i look at designe...
Is there a generic sdk_config.h file for each of the Nordic SDKs?
The ones included for each example seem to be missing useful macros/defines, for example, omission of SEGGER_RTT_CONFIG_DEFAULT_MODE...
