Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
We will inquire about the RF identification code.
I am in the process of certifying the product before mass production.
The certification body is requesting data on the...
Hi
I used nRF5_SDK_14.2.0 to develop nRF52832. Now I have a problem. I used the demo of ble_app_blinky in the ble_peripheral files. I want to send the 2552 bytes by ble_lbs_on_button_change...
Dear Sir,
I am implementing a program in which I need to stop advertising inside the function ble_evt_handler() .
I am starting the advertising by calling the function...
Hi everyone, for the project I'm developing it's extremely important to measure RTT as accurately as possible and as such, after some SoftDevice specification I imagined the...
Hi,
I am using Ble_app_gatts central example. Applied filter on name and connection made with some device which is not Nordic BLE device.
As in this central code, after...
Hi All,
I am using Keil and GCC but I want to migrate my projject to "Seggers Embedded Studio for ARM". After following the tutorial about migration, i have been able to...
I've been doing some exercises with the FDS module to ensure I understand it and have come across an issue. When I write I am not seeing a write call-back in the fds_event_handler...
I do not know why the comparator does not compare correctly. I use AIN6 as Vin+; ANI0 as Vin-. The code is show in below. The comparator is work in differential mode.
...
Hello,
I am using the following
Mesh Version : nrf5_SDK_for_Mesh_v2.2.0_src
SDK Version : nRF5_SDK_15.0.0_a53641a
IDE : SEGGER Embedded Studio for ARM Release 4.10...
Just wondering if anyone knows a reliable method to update a project to use a new SOFTDEVICE version?
One that can be repeated for each new release.
I am using Segger...
Hi,
I have a question about pairing a phone with the nrf52832.
During the pairing phase (the phone see our device that is advertising and then starts the paring procedure...
Hello,
i am facing issue with nRF5x Command Line Tools. I am using custom board with nRF52832. While i am using Segger J-flash Lite there is no problem to flash program...
I am developing a wearable using nRF52832 and looking for best debugging practice. I have given provision for SWD pin connection on PCB board. What is the best suitable JLink...