But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi All,
I would like to make bluetooth data collector with a serial line. There are max 16 bluetooth devices on the air where I need to collect data. There is a PC which...
Hi;
I was trying to run example project ble_app_hrs_freertos from SDK 13.1 (softdevice 4.0) using the IAR project files (compiler 8.11), and the ble output does not yield...
while i am trying to scan my ble device i have seen the following screen on my nrfconnect app. so i have a doubt in the screen , please let me know what is mean by the "BrEdrNotSupported...
I recently use the uart with nRF51822，but I can not find the APP for Android，can anyone give me a link ？I have no permition to download from the official website
I am trying to use read/write authorisation on a characteristic in order to get/set a connection specific value of a characteristic
I am am having issues getting the new...
Greetings,
In my application I have another device (STM32) communicating to a NRF52 via UART. When the STM32 needs to be reset, the NRF52's RX pin is pulled low. When the...
My goal is to have a writeable characteristic that I can reject on my peripheral, based on the state of the application.
In my test application, based on the nus uart service...
Hi guys,
I'm trying to start with a simple IO toggle program on the nRF52 on a Thingy52 board. I have erased the micro so there is no soft device. I'm working in Eclipse...
I just downloaded SDK 13 and noticed that S130 (nRF51x) is no longer supported.
Does this mean that there won't be any bug fixes for the SDK / API for anyone using the...
I've followed migration document of S132 5.0.0 and to my positive surprise my existing SDK 13.1.0 code for nRF52832 seems to run without issues.
Are there any caveats of...
When starting nRFgo studio it crashes instantly. I have tried uninstalling it several times. It appears to install correctly including all the J-xxx components, but will not...
