Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I am using the Dynastream D52DK1 ANT starter kit -based on Nordic Semiconductor’s nRF52832. According to the documentation given by Dynastream,
Open the desired project...
Hej, I stumbled upon a linker error saying
Output/serial_pca10040 nrf52832_xxaa/Obj/hardfault_handler_gcc.o: In function `HardFault_Handler_Continue':
hardfault_handler_gcc...
Hi, I really hate to ask this question but so far I have only managed to find 2 similar questions with 0 about nrf52840.
I'm using nrf52840 S140 5.0 alpha3.
When calling...
Hello
I have a problem...
'python_packages.bat' file can not be installed...
error message:
'python' is not an internal or external command, executable program,...
I have the nRF51-DK working on two separate computers with Keil v5.13 and the latest SDK. However, on my main computer I am having trouble with Keil and nRF51-DK. When I try...
Reference circuitry for nRF52832 with internal LDO setup says that C6 should not be mounted. Does it mean that DEC2 pin (32) should be simply grounded or it can be left open...
Hello everyone,
Im triying to replace the original 3D imagen from Thingy 52 Android App, but always i replace it for another one, the apps Crash when i go to Motion menu...
I have been developing a program for the nRF51-DK that reads an input value from an analogue input pin and displays this on PuTTY(terminal emulator software) using the UART...
This is for the nRF51822.
I have done some tests where I configure a pin as input with pull up enabled and then reconfigure the pin for an adc measurement with 1/3 prescaler...
Hi,
Just wanted to point out that I noticed that after pressing Button 1 to put the device into connectable advertising mode, LED 3 turns on as expected. But if the connectable...
I want to make a PCB with the nRF51422 chip on it. Is there a way of programming it externally using the nRF51-DK? If so, what connections do I need between the PCB and the...
