Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi I want to connect the system with random passkey, i modified the code like below the central is giving the passkey and i entering the passkey at device but not able to...
Hi,
first of all: Thank you very much for providing such a great tools as the nRF Connect Desktop tool!
I've installed the tool today and discovered, that the nRF Connect...
I'm trying to update firmware of nRF9160 DK, but fails.
I downloaded nRF9160 Modem Firmware and Modem DFU Tool from this page; https://www.nordicsemi.com/Products/Low-power...
DFU has worked fine until just recently.
Our custom hardware is using the nRF51822 and softdevice 8. We are using non-secure DFU.
We are using the latest nrFConnect. We...
Hi,
I'm trying to flash my device. Until yesterday, this command ran just fine and I was able to flashing my nRF51 chip. But I'm unable to do so anymore and can't figure...
Hello everyone,
I write this post because I haven't been able to find a solution to a problem I'm having to implement a parallel to serial converter. I am employing the...
Hi,
I am using the NRF52840, softdevice: s140, example: ble_app_uart from nRF5_SDK_15.2.0_9412b96.
short description of my application: i am developing an application...
Hi there,
I have been testing with the nrf9160 DK for a while now and I cant figure out how to get the device to sleep properly. I have been working with the asset_tracker...
Hi,
I've installed nRF sniffer version 2-0-0-beta on nRF52832 DK and verified it with BLE Beacon example. It works nice.
But when running light-switch example from Mesh...
Hi Nordic Team
We are working on BLE Modules which includes the chip-set nRF51822 and nRF52832.
We have tight form-factor and want to have longer range communication so...
Hi, I have a problem with waking up a device, description as below.
Application description: I made some application which is based on Serial example - all is working fine...
Hi
What is the default PHY when using NRF52832, SDK 14.2 and SD S132 v5.0?
When does a device's PHY get reset to this default value? Is it upon disconnect or is it as...
