hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
I am planning to migrate to SD 7.0 and SDK 6.0 in order to use the static pass key capabilities. When using the static pass key how should security params be initialized ...
Hi Hakon.... when i compile my project i get some linker errors,
._build\gzll_host_ack_payload.axf: Error: L6218E: Undefined symbol __main (referred from arm_startup_nrf51...
I'm trying to perform communication between my device and iOS and I ran into some problems. For tests I'm using iPod touch 5 with nRF Toolbox and LightBlue apps and nRF51822...
I've been using Master Emulator API 2.1.3 in Visual Studio 2010 Express, and have spotted a fix I may need in 2.1.5 so I've switched to using the 2.1.7 API. However, I've...
Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
Hi,
I am developing firmware based on nRF51822 SDK for s110.
I would like to modify one or two bytes at Manufacturer Specific Data area in advertising data packet.
But...
Using nrf51822's PCA10001EK and trying the included s110 example called ibeacon. Keep hitting error 0x3001 which corresponds to "connection handle" error.
This error is...
I have not been able to make this app work. I programmed S120 as softdevice and loaded the application. Ran into problem with scatter file. I changed it based on the s120...
When sending data on a pipe with ACK (indicate), the acknowledgement seems to get lost if the device gets disconnected right after having sent that data. Is that a normal...
Hello,
I am trying to build a single device, lets say loaded with firmware "A".
I would like to have two of these devices, both with firmware "A" to detect proximity...
I can't find anything to indicate for sure that the S120 BLE softdevice will work on the nRF51422 BLE/ANT chip. I'm pitting BLE vs ANT for my current use case and being able...
nRf51422 flash data retention is 10 years at 40°C. We need for our application (motor control roller shutter) 20 years. What can you do to increase this value?
Hi All,
Please correct the following in my understanding. Also , i am planning to build a
remote controlled device using a PWM output. How does ATT,GATT and GAP affect/influence...
I recently purchased an nRF51822-mKIT and I'm having great difficulties in getting it to talk to either a Windows 7 or a Windows 8 desktop PC, or a Ubuntu linux desktop PC...
Hi.
I have just a question:
Can the same device work with gazell protocol and bluetooth LE alternatively?
I want a net with a host and some devices, but host must be...
I've somehow lost the ability to perform over the air DFU from Master Control Panel.
I have reinstalled the J-Link drivers, nrfgo studio, I've flashed the PCA10000. I can...
My board works most of the time are very good，but one time i power down the board when ble connecting and data transmitting，the board can't work when power on.and i can't...
Hello,
I am trying to use ble_app_uart example from pca10001 to nrf6310 board from development kit. My nexus 7 detects the BLE device as 'Nordic_UART' but disconnects immediately...
