I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
The bluetooth device keeps getting disconnected from the app, even when its not 'idle'.
I am using the android app mentioned here .
I need help getting started to solve...
Moving from SDK version 5.1 to 6.0, the buttons on my PCA20006 beacons no longer works as expected. When I press a button, it seems to register the release of a button incorrectly...
I m working on SDK-11, and using sample program experimental_ble_app_blinky, in this code I want to read RSSI value and want to show on NRF Connect app. But its not showing...
Hello,
We are using nRF52832 DK, nRF52 sdk15.0 with SES IDE in windows 10. Currently we have senor network which is trigger every 1 Hr and send data trigger time set in...
The hardware is a custom board with a Rigado BMD300 module (which uses the nRF52832). I am using Softdevice S132.
My code base started as the ble_app_uart peripheral example...
Good afternoon,
In my peripheral application (SDK15 and Softdevice6.0.0) I can have several bonded central peers but only 1 can be selected on demand for the whitelist...
Dear all
Does the nRF52840 provide an unique device address (MAC) address, or that address has to be provided by the application layer to the stack/chip ?
Regards...
I am inquiring about the range of the nRF52840 USB dongle. I see a meandering antenna on the PCB. This is different from the DK's and am wondering if the meandering antenna...
Hello,
I'm trying to quickly prototype a BLE radio tester and was thinking of trying to use the nRF52840 Dongle as the BLE central to simply pair and read a couple of basic...
Hello,
I have two nrf52832 own boards. First is BLE_central receiver, second is BLE_peripheral transmiter.
SDK 15, SD-140.
I need to pair specyfic transmiter with specyfic...
Hi Sirs:
I am trying to change a characteristic property from "notify" to "indicate".
And the example I used was SDK15-> ble_app_uart .
I have ref these document：
...
Hi,
I'm trying to implement the buttonless DFU service example for SDK 12.3.0 into my own project, but when I call ble_dfu_init my compiled .hex file becomes 10 kb larger...
Hi,
I am working on SDK-14.2 and after execution of code i get this two error mention below.
sd_ble_cfg_set() returned : Unknown issue when attempting to set BLE_CONN_CFG_GAP...
Hi I have implemented a controller device using nRF52832. The controller device is installed in an industrial control box where it is used to control relays that subsequently...
