I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
The bluetooth device keeps getting disconnected from the app, even when its not 'idle'.
I am using the android app mentioned here .
I need help getting started to solve...
Moving from SDK version 5.1 to 6.0, the buttons on my PCA20006 beacons no longer works as expected. When I press a button, it seems to register the release of a button incorrectly...
Hello,
I have been developing firmware on a custom nRF51 board.
Upon testing firmware that involved BLE advertising,scanning, UART communication over BLE and FDS, i observed...
hi i have made gate opener for my farm, i am using MPU9250 and nrf52 to measure how much degree its open i am putting my MPU in cycle mode to wake up and take data, but it...
Hello
I would like to point out that I have no knowledge of electronics.
I am in the advanced stages of building a project on the basis of Adafruit feather nRF52832, The...
I am trying to test the fatfs example (SDK14) using the 10056 DK.
I do nothing modification and it results in...
<info> app: FATFS example started. <info> app: Initializing...
I realize I am like the hundredth person to have this problem but all the solutions I have found don't seem to work.
I am trying to add a simple header file to the nordic...
I am new to Nordic, I am able to compile and run examples on nRF52-DK.
I know there are examples are done for us but how I can develop my own project which use multiple...
I just replaced SDK 14.0 with the shiny new SDK 14.1 in my project. My project uses components from the SDK, but I don't use the exact same structure. Once again, it won't...
My Environment
Nrf52840
SDK : nrf51_15.0.0
soft device : s140
Target : Scanner (central)
I am trying to set GAP parameter for listening single channel that is...
i use sdk14.2 52832 i use uart
UART0_CONFIG_USE_EASY_DMA =1 consumption ~2.1mA
UART0_CONFIG_USE_EASY_DMA =0 consumption ~650uA
Is this a normal phenomenon, is it true...
Hi,
I have a Development and Evaluation board by Waveshare and i have a nRF51822 board. I have downloaded the nRFgo studio and i have used a USB to UART board and connected...
Hi
I am developing an application where nrf52 acts as a BLE central
Specifications requires that this node should connect to a peripheral with a specified name, obviously...
I have 2 services are running using 16 bit UUIDs and now I am adding another service using our_service.c and our_service.h files but my program is crashing and leading to...
