Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Which Nordic MCU's, if any, support odd parity for UART? 0

Hi, I have a project requirement to interface with HART, which is a protocol that specifies odd parity for UART. I recently found out UART odd parity isn't supported on...
6 views

0 replies

Started 13 minutes ago
by chris_h
Not Answered
CS 3.1.0 + nRF5340: MCUboot serial recovery in single-slot with signing + encryption 0

Hi Nordic team, I am working on nRF5340 and trying to enable MCUboot serial recovery DFU in single-slot mode with both signing and encrypted images. Environment: 1. SoC...
16 views

0 replies

Started 2 hours ago
by BBatu
Not Answered
nPM1300: VSYS drops to 2.5V on startup unless VBUS and VSYS are momentarily shorted 0

Hello Nordic Support Team, I am experiencing a startup issue with the nPM1300 PMIC. Below is the summary of my hardware configuration and the behavior I am observing: ...
17 views

0 replies

Started 3 hours ago
by Luis Santos
Not Answered
nRF52811: settings_save_one() returns -2 / -116 while storing device name and BLE passkey issue (Settings + NVS backend) 0

Hi Team, I am working on an nRF52811-based BLE application using nRF Connect SDK (Zephyr) and facing an issue while trying to store the device name in flash using the Settings...
19 views

0 replies

Started 6 hours ago
by Manoj Kumar
Not Answered
[NCS 2.9.0] Wi-Fi SoftAP + BLE Coexistence 2x (nRF5340 + nRF7002): Complete Wi-Fi starvation upon BLE Adv start, leading to RPU crash. 0

Hello Nordic Support, We are developing a project using two setsof nRF5340 DK with the nRF7002 EK attached. We are trying to achieve coexistence between Wi-Fi in SoftAP...
- beacons
- Evaluation
- configuration
- zephyr
- hardware
- nRF5340
36 views

0 replies

Started 9 hours ago
by wbezs

Recent in the DevZone Blog

Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016
An introduction to error handling in nRF5 projects

Audun

As you start developing with the nRF5 series chips, SoftDevices, and SDKs, it's very useful to learn how errors can be discovered (and preferrably recovered from). This can be detecting something as simple…
- 20 Jan 2016
iBeacon application example with nrf51

Marco Russi

Hi all, I developed an iBeacon application example with nrf51 chip-set. The firmware has been developed on top of softdevice s110 and Nordic SDK running on a nrf51 PCA10028 Dev. Kit. I used an arm-eabi…
- 12 Jan 2016
Nordic Semiconductor wins prestigious GSA award

John Leonard

Most outstanding EMEA Semiconductor Company An award from the Global Semiconductor Alliance (GSA) is widely considered as one of the tier 1 awards that a semiconductor company can receive. Nordic Semiconductor…
- 12 Jan 2016