Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Multiple soldering issues 0

We are seeing very high defect rate when installing this part on boards: insufficient solder, solder bridging. When we look at the pads under the microscope, we are seeing...
23 views

0 replies

Started 3 hours ago
by Loan Thai
Not Answered
nRF9151 puts wrong network in FPLMN 0

Hello, We have an issue. Our device is a custom board based on the nRF9151, and we use it in Latvia. Two network providers are available for our Onomondo SIM card: one supports...
- software
- lte-m
- nb-iot
- nRF9151
- production
31 views

0 replies

Started 8 hours ago
by Matiss
Not Answered
Security Updates for nRF52840 beyond 2031 0

Hello, We are developing a product based on the nRF52840. According to the blog post nRF Connect SDK gets Long-term support with version 3.4.0 , NCS v3.4.0 declares the...
53 views

0 replies

Started 12 hours ago
by Luzian
Not Answered
Request for Optimal Battery Solution for nRF54L15 Matter End Device 0

Subject: Request for Optimal Battery Solution for nRF54L15 Matter End Device Hello DevZone Team, I am opening this ticket to identify the optimal power solution for my...
- battery
- Evaluation
- nRF54L15
- hardware
- nPM1300
97 views

0 replies

Started 13 hours ago
by IOANNIS0
Not Answered
nRF21540 DK Scanning RSSI Does Not Go Below -80 dBm with FEM (LNA) Enabled 0

Hardware: nRF21540 DK SDK Version: NCS 3.4.0 Problem Description: Modified the observer sample to scan for a specific device, using nRF21540 DK as the scanner with FEM...
92 views

0 replies

Started 4 days ago
by Bobing

Recent in the DevZone Blog

Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015